8211 COUPLING 3M, 8211 COUPLING Datasheet - Page 22

• Manufacturer Part Number: 8211 COUPLING
• Description: COUPLING F/OPTIC FC SM D-MOUNT
• Manufacturer: 3M

Specifications of 8211 COUPLING

• Convert From (adapter End): FC Simplex Receptacle
• Convert To (adapter End): FC Simplex Receptacle
• Mode: Singlemode
• Mounting Type: Panel Mount, Bulkhead
• Lead Free Status / RoHS Status: Vendor undefined / Vendor undefined
• Features: -
• Other names: 5113811913; 51138119133; 80-6107-4233-2; 80610742332; 8211 COUPLING; 8211 COUPLING FC/PC; MF8211

11.7 Place the connector ferrule in
11.10 Place the jig on the lapping film.
11.13 Beginning with a light
11.16 Wipe a layer of alcohol onto
the polishing jig to verify that
it fits properly. The fit should
allow for easy movement of
the ferrule.
pressure, move the jig in a
figure eight pattern.
the rubber pad.
11.8 If the ferrule does not fit
11.11 Place the ferrule in the jig
11.17 Before the alcohol
11.14 The speed of your figure
Note: The jig will feel much easier
properly, there are two possible
causes. The first is that there
is adhesive on the ferrule. To
remove the adhesive, use the
scissors and gently scrape
away the adhesive.
until it stops.
evaporates, place the 0.05
Micron Lapping film (pale
yellow) on the rubber pad
shiny side down.
eights should be between one
and two per second.
After you have done 5 figure
eights, increase to a medium
pressure and polish until all of
the adhesive has been
removed. Then, polish one
additional figure eight only.
to push immediately after the
adhesive has been removed.
22
11.12 Hold the connector as shown.
11.15 Clean the second rubber pad.
11.18 Clean the lapping film with a
Note: The SM Final Polish film
11.9 The second possibility is that
the hole in the jig may have
adhesive in it. Saturate a pipe
cleaner with isopropyl alcohol
and move it back and forth in
the jig to remove the adhesive.
lint free cloth moistened with
isopropyl alcohol.
may be used for up to 8
connectors.