CV500RM211 Omron, CV500RM211 Datasheet - Page 30

no-image

CV500RM211

Manufacturer Part Number
CV500RM211
Description
Programmable Logic Controller
Manufacturer
Omron
Datasheet

Specifications of CV500RM211

Peak Reflow Compatible (260 C)
No
Leaded Process Compatible
No
Lead Free Status / RoHS Status
Contains lead / RoHS non-compliant
Example 3
4-3-2 Preparing a Cable for Pulling
Cable Without a Connector
1, 2, 3...
tain climbers when the rope is tied around the body and can be mastered quickly
by beginners.
If the cord is being pulled through a relatively large conduit, a cord can be folded
back onto itself and taped to make a loop. If this method is used, the end of the
cord which was folded will be damaged and cannot be used to transmit light. Cut
off the end of the cord after it has been installed.
Optical Fiber Cables must not be pulled by their optical fibers or power wires, but
by the cable’s tension member. The methods described here will not make the
end of the cable watertight. If the cord is being pulled through water, be sure to
treat the end of the cable so it is watertight.
Follow the procedure below to prepare an Optical Fiber Cable without a connec-
tor attached.
1. First remove 300 to 500 mm of the outer PVC sheath from the end of the
2. Cut the Optical Fiber Cords, power wires, and spacing cords so that the ten-
3. Cover the Optical Fiber Cords and power wires with a protective tube or cov-
4. Tie the exposed tension member to the steel pulling wire.
Optical Fiber Cable (1).
sion member (3) protrudes.
er and wrap the end of the cable with PVC tape.
Steel wire
(pulling wire)
Tension member (3)
300 to 500 mm
Optical Fiber Cord or Power Wire (2)
PVC adhesive tape (4)
Optical Fiber Cable (1)
Section 4-3

Related parts for CV500RM211