SI-HG80DQD BANNER ENGINEERING, SI-HG80DQD Datasheet
SI-HG80DQD
Specifications of SI-HG80DQD
Related parts for SI-HG80DQD
SI-HG80DQD Summary of contents
Page 1
... SI-HG80DQD QD Fitting Right-Angle SI-HG80DQDR QD Fitting NOTE: Terminal #3 is non-safety Printed in USA Hinge Wing Safety Interlock Switches SI-HG80 Series Safety Interlock Switches Encapsulated in a Load-Bearing Hinge • Safety switch is integrated and encapsulated into a load-bearing hinge, providing a high degree of protection from intentional defeat • ...
Page 2
... ISO 13849 (EN954-1). In addition, the user of Banner safety switches has the responsibility to ensure that all local, state, and national laws, rules, codes, and regulations relating to the use of Banner safety switches in any particular application are satisfied. Extreme care is urged that all legal requirements have been met and that all installations and maintenance instructions are followed ...
Page 3
... Position blank hinges (if used) and the hinge switch(es) on the guard or gate while its fully closed and latched position. Verify that the axis of rotation is identical for all hinges used. (Typically, this can be accomplished by using a straight edge along the long flat edge to ensure the switch bodies are parallel ...
Page 4
... This necessary reset function is required by ANSI B11 and NFPA 79 machine safety standards. Use only the positively driven, normally closed safety contact (between pins 1 and 2) from each switch for connection to the safety module. A typical use is to communicate with a process controller ...
Page 5
... A designated person is identified in writing by the employer as being appropriately trained to perform a specified checkout procedure. Do not attempt any repairs to the switch. It contains no field-replaceable components. Return the switch to the factory for warranty repair or replacement. ...
Page 6
... See page 7 for blank hinge dimensions. P/N 46735 rev. B Specifications -25° to +70° C (-13° to +158° F) Dimensions 4x 6.5 mm (0.25") R9.0 mm 15.5 mm (0.61) 19.0 mm (0.75") Model SI-HG80DQDR 21.0 mm (0.83") 11.5 mm (0.45") 15.5 mm 19.0 mm (0.75") 23.6 mm 10.0 mm (0.93") (0.39") M12 x 1 Note Hole Recommended Banner Engineering Corp. • ...
Page 7
... Micro-style, MQEAC-15RA 5 m (15') Right-angle MQEAC-0RA 9 m (30') Model Description Same mechanical specifications as SI-HG80A SI-HG80 Series Hinge Switches Banner Engineering Corp. • Minneapolis, MN U.S.A. www.bannerengineering.com • Tel: 763.544.3164 Hinge Switches – Accessories Quick-Disconnect Cables Dimensions ø15 mm (0.6") M12 max. ...
Page 8
... Hinge Switches – SI-HG80 Series WARRANTY: Banner Engineering Corp. warrants its products to be free from defects for one year. Banner Engineering Corp. will repair or replace, free of charge, any product of its manufacture found to be defective at the time it is returned to the factory during the warranty period. This warranty does not cover damage or liability for the improper application of Banner products ...