DMS-20-CP Murata Power Solutions Inc, DMS-20-CP Datasheet - Page 3

• Manufacturer Part Number: DMS-20-CP
• Description: PANEL CUTOUT PUNCH FOR DMS-20CP
• Manufacturer: Murata Power Solutions Inc
• Type: Panel Punchr

Specifications of DMS-20-CP

• Signal Input Type: Voltage, Current
• Equipment Type: Panel Punch
• Lead Free Status / RoHS Status: na
• Lead Free Status / RoHS Status: na, Lead free by exemption / RoHS compliant by exemption
• Other names: 811-1121

THIS IS A HAND TOOL AND USE OF POWER TOOLS INSTEAD OF THE ALLEN WRENCHES PROVIDED VOIDS ALL WARRANTIES.
Murata Power Solutions, Inc.
11 Cabot Boulevard, Mansfi eld, MA 02048-1151 U.S.A.
ISO 9001 and 14001 REGISTERED
1. IT MAY be to your advantage (in the interest of speed) to make a metal template
2. CENTER PUNCH at the points you have marked.
3. DRILL the outer two holes with a 13/64 inch drill; drill the center hole with a 21/64
4. CLEAN and LUBRICATE the area to be punched. Any oil (or even vegetable short-
5. INSERT these three Draw Screws into their holes on the punch,
6. AFTER properly aligning punch to die and snugging the 3 draw screws hand tight,
7. REMOVE the 3 draw screws after the hole is punched and the die should readily
8. REMOVE the punch from the panel. Tapping the punch lightly with a hammer will
9. REMOVE the slug. Thread the 2 ejector screws into the bottom of the die and tighten
using dimensions provided with the layout drawing. In any event, locate, mark,
center punch and drill these three holes according to items (2) and (3) below.
inch drill.
ening) will allow the punch to work easier.
through the 3 holes you drilled in the panel, and thread them into their holes in the die.
use the hex keys to tighten the draw screws (alternately if necessary) and thus cut
the hole. When cutting lighter material, the entire hole can usually be made by use of
the center draw screw only; the screws on either side are then used only to correct
any tilting of the punch as related to the die.
release from the punch.
make it move easily through the panel.
until the slug is forced from the die.
www.murata-ps.com/locations
INSTRUCTIONS
Panel Cutout Punch and Instructions for Use with All
Murata Power Solutions, Inc. makes no representation that the use of its products in the circuits described herein, or the use of other
technical information contained herein, will not infringe upon existing or future patent rights. The descriptions contained herein do not imply
the granting of licenses to make, use, or sell equipment constructed in accordance therewith. Specifi cations are subject to change without
notice.
DMS-20-CP Panel Punch
10 Dec 2010 MPM_DMS20-CP.B02 Page 3 of 3
DMS-20-P Series Meters*
email: [e-mail]
© 2010 Murata Power Solutions, Inc.