INFS-0200-DC1 NEWPORT ELECTRONICS, INFS-0200-DC1 Datasheet - Page 55

• Manufacturer Part Number: INFS-0200-DC1
• Description: Strain Gauge Meter
• Manufacturer: NEWPORT ELECTRONICS

Specifications of INFS-0200-DC1

• No. Of Digits / Alpha: 6
• Meter Range: 0mV To 100mV
• Digit Height: 13.7mm
• Power Consumption: 6W
• Operating Temperature Range: 0°C To +50°C
• Signal Input Type: 0 To 100mV Voltage
• Lead Free Status / RoHS Status: na

If the nonzero reading is fluctuating between two numbers, convert
the smaller count value to the offset value, then add a 5 just right
of the decimal point. This adds half a count to the offset. For
example, the display if flucuating between 00.0001 and 00.0002.
Calculate the offset using the 000001 count value. The converted
offset value is -1.0000. Add a 5 to the right of the decimal point:
the final offset value is -1.5000.
PRESS
‘MENU’
‘MIN’
‘MIN’
‘MENU’
‘RESET’ ‘RESET’
THEN PRESS
(TO CHANGE DISPLAY
IF REQUIRED) SHOWS
‘MAX’
8-11
“RESET2”
UNTIL
“RDG OF”
“000000.”
“XXXXXX”
“STORED”
then
“IN CNF”
the then
Measured
Value
COMMENTS
Press the ‘MENU’
button until the display
shows “RDG OF”.
Press the ‘MIN’
button and the display
will show the last
offset entered.
Use the ‘MIN’ to
move to each digit and
the ‘MAX’ button to
change the flashing
digits value and enter
your zero offset
number.
Press the ‘MENU’
button to store
your selection. The
display will momen-
tarily show “STORED”
then “IN CNF”.
Press the ‘RESET’
button two times. The
display will momen-
tarily show “RESET2”
and then will display
the currently
measured values.
Scaling to
Display
Engineering
Units
8