ELC-EX08NNAN-1 EATON CUTLER HAMMER, ELC-EX08NNAN-1 Datasheet - Page 9
![Programmable Logic Controller](/photos/21/26/212677/4551006_sml.jpg)
ELC-EX08NNAN-1
Manufacturer Part Number
ELC-EX08NNAN-1
Description
Programmable Logic Controller
Manufacturer
EATON CUTLER HAMMER
Datasheet
1.ELC-EX06NNNI-2.pdf
(34 pages)
Specifications of ELC-EX08NNAN-1
Signal Input Type
AC Voltage
No. Of Inputs
8
For Use With
Eaton ELC Controllers
February 2009
ELC Power Supplies
All ELC controllers, analog and spe-
cialty expansion modules operate from
24V DC. These power supplies provide
a convenient way to provide robust DC
voltage for ELC and other products.
Figure 50-6. ELC Power Supplies
Table 50-6. ELC Power Supply Specifications
ELC Accessories
ELC Storage Devices
ELC-ACPGMXFR
The ELC-ACPGMXFR module is a
multifunction device that provides
the ability to back up an application
already loaded onto one of the ELC
controllers. The transfer module can
be used for copying the same applica-
tion to multiple controllers and to
transfer an existing application to a
new controller in the event of a failure.
It will store system settings, pass-
words and the application including
the data registers for pre-loaded reci-
pes. Once stored in the module, the
application, data registers and settings
can be transferred to another ELC con-
troller of the same model number.
CA08102001E
Item
Dimensions W x H x D in Inches (mm)
Input Power
Output Volts
Output Current (A)
Watts
24V
0V
N
ELC-PS01
L
POWER
ELC-PS01
1.44 x 3.54 x 2.36 (36.5 x 90 x 60)
1A
24
ELC Cables
ELC-CBPCELC1 and ELC-CBPCELC3
Use these cables to download, upload,
and monitor ELC controllers or to con-
nect any ELC-GPxx to an ELC control-
ler. The ELC-CBPCELC1cable is 1 meter
long and has a right connector to the
ELC controller to help reduce depth
when cable is attached. The ELC-
CBPCELC3 is 3 meters long with a
straight connector.
For more information visit: www.eaton.com
PLC, I/O & Communications Products
ELC Programmable Logic Controllers
ELC Controllers / Modules
100 – 240V AC 50/60 Hz
24V DC
24V
0V
N
L
ELC-PS02
2.17 x 3.54 x 2.36 (55 x 90 x 60)
2A
48
ELC-HHP Hand-Held Programmer
ELC-HHP
ELC-HHP is an easy-to-use, hand-held
programming and monitoring tool for
ELC controllers when a PC is not avail-
able. With ELC-HHP, applications can be
programmed directly with the attached
keypad. Applications can also be
uploaded from an ELC, saved and
transferred to a different ELC, or down-
loaded from a PC and transferred to
other ELCs. External power is not
required when using the hand-held pro-
grammer because it draws its power
from either the ELC or the PC through
the attached cable.
ELC-ACCOVER Plate Mount
Use the ELC-ACCOVER surface mount
stand-alone modules instead of
mounting to a DIN-rail. This may be
used to mount analog, temperature
or the RS-485 adapters remotely.
50-9
50