HFBR-EUS100Z Avago Technologies US Inc., HFBR-EUS100Z Datasheet - Page 6
HFBR-EUS100Z
Manufacturer Part Number
HFBR-EUS100Z
Description
FIBER OPTIC CBL SIMPLEX 1=100M
Manufacturer
Avago Technologies US Inc.
Type
POFr
Series
HFBRr
Specifications of HFBR-EUS100Z
Length - Overall
328.1' (100m)
Cable Diameter
0.09" (2.2mm)
Cable Type
Buffered Fiber
Features
Attenuator
Jacket (insulation) Material
Polyethylene (PE)
Operating Temperature
-55°C ~ 85°C
Color - Cable
Black
Color - Connectors
Black
Jacket Color
Black
Jacket Material
Polyethylene
Length
100 meters
Outside Diameter
1 mm
Reel Length (imperial)
328.1ft
Reel Length (metric)
100m
Fiber Diameter
1mm
No. Of Fibers
1
External Diameter
2.2mm
Rohs Compliant
Yes
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
2nd Connector
-
1st Connector
-
Fiber Type
-
Lead Free Status / Rohs Status
Lead free / RoHS Compliant
Other names
516-2086
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Company:
Part Number:
HFBR-EUS100Z
Manufacturer:
EMCT
Quantity:
1 400
Step 3
Any excess fiber protruding from the connector end may
be cut off; however, the trimmed fiber should extend at
least 1.5 mm (0.06 in) from the connector end.
Insert the connector fully into the polishing fixture with
the trimmed fiber protruding from the bottom of the
fixture. This plastic polishing fixture can be used to polish
two simplex connectors or simplex latching connectors
simultaneously, or one duplex connector.
Note: The four dots on the bottom of the polishing fixture
are wear indicators. Replace the polishing fixture when any
dot is no longer visible. Typically, the polishing fixture can
be used 10 times; 10 duplex connectors or 20 simplex con
nectors, two at a time.
Place the 600 grit abrasive paper on a flat smooth surface,
pressing down on the connector, polish the fiber and the
connector using a figure eight pattern of strokes until
the connector is flush with the bottom of the polishing
fixture. Wipe the connector and fixture with a clean cloth
or tissue.
6
Step 4
Place the flush connector and polishing fixture on the dull
side of the 3 µm pink lapping film and continue to polish
the fiber and connector for approximately 25 strokes. The
fiber end should be flat, smooth and clean.
This cable is now ready for use.
Note: Use of the pink lapping film fine polishing step results in
approximately 2 dB improvement in coupling performance
of either a transmitterreceiver link or a bulkhead/splice over
a 600 grit polish alone. This fine polish is comparable to the
Avago factory polish. The fine polishing step may be omitted
where an extra 2 dB of optical power is not essential, as with
short link lengths. Proper polishing of the tip of the fiber/con
nector face results in a tip diameter between 2.5 mm (0.098
in.) minimum and 3.2 mm (0.126 in.) maximum..
HFBR-4593Z Polishing Kit