PAF600F280-28 TDK Corporation, PAF600F280-28 Datasheet - Page 44

• Manufacturer Part Number: PAF600F280-28
• Description: 28V@21.5A
• Manufacturer: TDK Corporation

PAF
B-136
PAF
Be sure to take note of precautions and warnings indicated in
this manual when using this product. Improper usage may lead
to electric shock or fire. Be sure to read this instruction manual
thoroughly before using this product
● Avoid touching the baseplate and the case of this product
● There are high voltage and high temperature components
● To avoid unexpected accident from placing hands or face
● Confirm connections to input/output terminals and signal ter-
● Attach a fast blow type external fuse to each module to
● This power module is designed for professional installation
● Output voltage of this product is considered to have hazard-
because they get hot.
within this product. Refrain from disassembling this product
or touching its internal components as this may lead to elec-
tric shock or burn.
near the unit during operation.
minals are correct as indicated in the instruction manual.
ensure safety operation and compliance to each safety stan-
dard approval.
within the end user equipment.
ous energy level (voltage of 2V and above with power of
Precautions
450F280, 600F280
PAF450F280, PAF600F280 SERIES Instruction Manual
[Input Side Terminals]
＋Vin ： ＋Input Terminal
−Vin ： −Input Terminal
[Control Terminals]
CNT ： ON/OFF Control terminal
SG ：
ON/OFF Control (ground side) terminal
−Vin
＋Vin
SG
CNT
Baseplate can be connected to FG through M3 mounting tapped holes.
Connect +Vin, -Vin, +V, -V with consideration of contacting resistance.
Before using this product
1. Terminal Explanation
Name Plate
● PAF-F24, -F48 Instruction Manual
● PAF400F280 Instruction Manual
● The application circuits and their parameter are for reference
● The information in this document is subject to change with-
● No part of this document may be copied or reproduced in
CE Marking, when applied to a product covered by instruction
manual, indicates compliance with the low voltage directive in
which complies with EN60950.
240W and above) and must not have physical contact with
operator. Protection must be provided on this module when
installed on equipment to prevent physical contact with ser-
vice technician himself or accidentally dropped tools during
repair. Before repair, be sure to turn off the input source and
confirm that input and output voltage have dropped down to
a safe level.
only. Be sure to verify effectiveness of application circuits
and their parameters before finalizing circuit design.
out prior notice. For actual design-in, please refer to the lat-
est publications of data sheet, etc., for the most up-to date
specifications of the unit.
any for, or by any mean without prior written consent of Den-
sei-Lambda.
Note : CE Marking
[Output Side Terminals]
＋V ： ＋Output Terminal
−V ： −Output Terminal
＋S ： ＋Remote Sensing
−S ： −Remote Sensing
TRIM ： Output Voltage Trimming Terminal
PC ： Output Current Balance Terminal
IOG ： Inverter Operation Good
AUX ： Auxiliary Power Supply for External Signals
・All specifications are subject to change without notice.
−V
−V
−V
＋V
＋V
＋V
GO!!
GO!!
B-
B-
126Page
108Page