SRDA05-6.TB Semtech, SRDA05-6.TB Datasheet - Page 5

• Manufacturer Part Number: SRDA05-6.TB
• Description: Diode
• Manufacturer: Semtech

Specifications of SRDA05-6.TB

• Leaded Process Compatible: No
• Peak Reflow Compatible (260 C): No
• Reel Quantity: 500
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

Device Connection Options for Protection of Six High-
Speed Lines
The SRDA TVS is designed to protect four data lines
from transient overvoltages by clamping them to a
fixed reference. When the voltage on the protected
line exceeds the reference voltage (plus diode V
steering diodes are forward biased, conducting the
transient current away from the sensitive circuitry.
Data lines are connected at pins 1, 2, 4, 5, 6 and 7.
The negative reference is connected at pin 8. These
pins should be connected directly to a ground plane on
the board for best results. The path length is kept as
short as possible to minimize parasitic inductance.
The positive reference is connected at pins 2 and 3.
The options for connecting the positive reference are
as follows:
1. To protect data lines and the power line, connect
2. The SRDA can be isolated from the power supply by
3. In applications where no positive supply reference
ESD Protection With RailClamps
RailClamps are optimized for ESD protection using the
rail-to-rail topology. Along with good board layout,
these devices virtually eliminate the disadvantages of
using discrete components to implement this topology.
Consider the situation shown in Figure 1 where dis-
crete diodes or diode arrays are configured for rail-to-
rail protection on a high speed line. During positive
duration ESD events, the top diode will be forward
biased when the voltage on the protected line exceeds
the reference voltage plus the V
For negative events, the bottom diode will be biased
when the voltage exceeds the V
PROTECTION PRODUCTS
PROTECTION PRODUCTS
Applications Information
2006 Semtech Corp.
pin 3 directly to the positive supply rail (V
configuration the data lines are referenced to the
supply voltage. The internal TVS diode prevents
over-voltage on the supply rail.
adding a series resistor between pin 3 and V
value of 10k
and steering diodes remain biased, providing the
advantage of lower capacitance.
is available, or complete supply isolation is desired,
the internal TVS may be used as the reference. In
this case, pin 3 is not connected. The steering
diodes will begin to conduct when the voltage on
the protected line exceeds the working voltage of
the TVS (plus one diode drop).
is recommended. The internal TVS
F
F
of the diode. At first
drop of the diode.
CC
). In this
F
CC
) the
. A
5
Data Line and Power Supply Protection Using Vcc as
reference
Data Line Protection with Bias and Power Supply
Isolation Resistor
Data Line Protection Using Internal TVS Diode as
Reference
SRDA3.3-6 and SRDA05-6
www.semtech.com