IRC160B AXIOHM, IRC160B Datasheet - Page 6

• Manufacturer Part Number: IRC160B
• Description: RIBBON, INK, BLK
• Manufacturer: AXIOHM

Specifications of IRC160B

• Rohs Compliant: YES

6
N.B: FIRST READ SECTION 2
Please refer to figure 2 for connector layout
6.1 POWER CONNECTOR J1
These products are fitted with a 0.1" pitch square wire, right angle, friction lock connector. A
suitable mating connector would be a Molex type 2695 part number 22-01-3037 and crimp terminal
Molex type 40445.
Pin
1
2
3
6.2
4-way 0.1" pitch polarised Molex (Mating connector type 22-01-3047 with crimp terminal type
40445)
Pin
1
2
3
4
6.3
3 position 0.1" pitch header.
The baud rate and default data inversion options are selected by fitting jumper links to the pins of
LK1 in the positions A, B and C shown in fig.2.
Inverted (reverse) data mode is enabled by fitting a jumper to LK1 in the position A.
The different baud rates are selected by fitting or removing jumper links to LK1 in the positions
shown below before applying power to the printer.
Baud Rate
1200
2400
4800
9600
6.4
2-way 0.1" pitch polarised Molex (Mating connector type 22-01-3027 with crimps 40445)
Please note that this connector is only suitable for ASL paper take-up device products.
Pin
1
2
In case of difficulty, or for advice on application of the these products please contact the factory.
CONNECTION DATA
SERIAL CONNECTOR J3
SERIAL BAUD RATE AND DATA INVERSION OPTIONS LK1 See fig. 2
PAPER TAKE-UP DEVICE J2 Fig. 2
Function
0V
+5V DC Power Input (Controller)
3 +5V DC Power Input (Mechanism)
Function
Serial data input (Rxd)
Serial data output (Txd)
Busy output (DTR)
Ground (Signal common 0V)
Function
Motor Positive
0V (Gnd)
B
Not fitted
Fitted
Not fitted
Fitted
(9.7.93) I.C.Sherwood (Converted to electronic format 22.11.01)
C
Not fitted
Not Fitted
Fitted
Fitted