DS00161 Microchip Technology, DS00161 Datasheet - Page 46

• Manufacturer Part Number: DS00161
• Description: Technical Library CD-ROM
• Manufacturer: Microchip Technology

Specifications of DS00161

• Tool Type: Manuals
• Lead Free Status / RoHS Status: na

ICEPIC™ User’s Guide
3.4
DS51103B-page 40
Setting Up the Development Mode
Use the Development Mode dialog to select the ICEPIC In-Circuit Emulator
for use with the MPLAB IDE software.
1. Select Options > Development Mode to display the Development Mode
.
2. Under the Tools tab, select the ICEPIC development mode and the pro-
3. Select the Ports tab to set the COM port that the ICEPIC In-Circuit Emu-
4. Select the Configuration tab to enable or disable the watchdog timer to
5. Select the Break Options tab to change the global break options.
6. When you are finished setting up the ICEPIC In-CIrcuit Emulator, click
dialog.
cessor you are going to use.
You may also access the Development Mode dialog from the Edit Project
dialog by clicking Change next to the Development Mode item. See
Chapter 2 for more information on setting up projects.
If the MPLAB IDE cannot find the ICEPIC In-Circuit Emulator, check your
hardware connections (Section 1.7) and then go to Step 1. If you still can-
not connect, see Chapter 5: Troubleshooting.
lator is connected to and the desired baud rate at which the data will
travel over the COM port.
reset the processor when the watchdog timer times out.
OK.
Note:
The MPLAB IDE will only display the processors that are com-
patible with the daughter board installed in the ICEPIC In-Cir-
cuit Emulator.
Figure 3.2: Development Mode Dialog
 2000 Microchip Technology Inc.