ECO42F TIMEGUARD, ECO42F Datasheet - Page 5

• Manufacturer Part Number: ECO42F
• Description: FLOODLIGHT, ENERGY SAVER, 42W
• Manufacturer: TIMEGUARD

Specifications of ECO42F

• Length: 260mm
• Depth: 285mm
• Base Type: ES
• External Depth: 285mm
• External Length / Height: 260mm
• External Width: 270mm
• Ip/nema Rating: IP44
• Power Rating: 42W
• Supply Voltage: 240V
• Svhc: No SVHC (15-Dec-2010)
• Lamp Base Type: ES
• Rohs Compliant: Yes
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

To fit the bulb, release but do not remove the two screws on the rear of the floodlight (diagram B).
Release the clips shown on diagram B at either side of the housing, the floodlight front cover
will open and rotate down but will not separate from the main floodlight body.
Remove the bulb from its packaging and fit into the lampholder. ensure the bulb is fully secured
into the lampholder and the support bracket is located around the bulb.
Close the front cover, ensure the clips are fully located (there will be an audible "click") and fully
tighten the two securing screws on the rear of the unit.
Mark the position of the wall fixing holes. ensure the wall plate is correctly positioned. note the
"Up" ident on the inside of the wall plate (diagram C).
Drill the holes, insert the wall plate into the holes.
pIeRCe AnD pASS THe CABLe THROUGH THe GROMMeT BeFORe SeCURInG THe WALL
pLATe TO THe WALL.
It is recommended that the grommet is pierced with a screwdriver to ensure a better seal.
Remove the cable clamp, feed the incoming cable under the cable clamp and secure. Do not
overtighten the cable clamp as it could damage the cable insulation.
Fix the wall plate to the wall (diagram C).
The unit is supplied with a hanging attachment (tether) to aid installation.
If it is not required, simply remove from the unit and discard.
ensure the tether is securely fixed into the slot before releasing the weight of the unit.
The unit can now be suspended below the wall bracket (fig D).
CONNECTION
Connect the cable to the terminal block on the unit as follows (see diagram e):
neUTRAL (Blue)
n
eARTH (Green/Yellow)
LIVe (Brown)
L
ensure Connections are secure.
ensure any extra cable and the tether is tucked into the space in the wiring box.
Fit the floodlight to the bracket by inserting the lug in the floodlight into the recess at the top
of the wall plate and locating the floodlight securely over the wall plate.
Fit and fully secure the locating screw (diagram A).
This floodlight uses a universal joint, it can be directed to suit your installation by rotating the
floodlight left to right and up or down. Secure in desired vertical position by use of the clamping
screws on either side of the floodlight joint (see diagram e).
Installation is complete!