TS-01-30-1000 IGUS, TS-01-30-1000 Datasheet - Page 6

• Manufacturer Part Number: TS-01-30-1000
• Description: LINEAR RAIL
• Manufacturer: IGUS
• Series: DryLin Tr

Specifications of TS-01-30-1000

• Width: 15mm
• Body Material: Aluminium
• External Length / Height: 300mm
• Lead Free Status / RoHS Status: na

1
1
2
3
4
2
3
4
DryLin
Adjusting the clearance: DryLin
DryLin
is adjusted at the factory. The preadjustment is determined by the
acting forces on each individual system. If you have special require-
ments, please indicate in your order whether particularly limited or
extended bearing clearance is required. If necessary, clearance of the
DryLin
take place when there is no load on the carriage.
Adjusting the clearance: DryLin
The DryLin
of the clearance. A readjustment can take place automatically in steps
of 0.1 mm. Springs tighten the regulating wedge immediately as soon
as the clearance is bigger than 0.1 mm and the system is unloaded.
Lifetime calculation, CAD files and much more support
After removing the protective cover, loosen the locknuts –
Width across flats:
Adjust the bearing clearance for the 3 guide points with an
Allen key – Allen key size:
Check the clearance of the carriage after adjusting the 3 levels.
If it is sufficient, tighten the locknuts and put on the cover.
There is a danger that excessive reduction of the clearances
can seize the gliding elements and that the clearance cannot
be reset simply by loosening the adjustment screws. The gliding
elements are then released by pressing the reset button on
the opposite side. Press hard against the readjusting spring.
You must have already loosened the respective adjustment
screws. Use the correct size pin for this purpose:
The system will be delivered with 3 spanners which are already
plugged in. They are necessary for mounting the carriage onto
the rail. In case these spanners are removed they need to be
replugged into the openings and turned right by 90°.
When the carriage is on the rail, loosen the spanners by turning
them left 90° and remove them. The clearance will be adjusted
automatically.
Check the clearance of the carriage. A fine adjusting can be done
at this point.
You can remove the carriage at any time. In order to do so,
simply plug the spanners back into the openings (see step 1).
®
®
T is delivered ready for installation. Clearance of the carriage
T linear guide system can be readjusted. This should always
SW 5 for TW-01-15 and TW-01-20
SW 7 for TW-01-25 and TW-01-30
1.5 mm for TW-01-15 and TW-01-20
2.0 mm for TW-01-25 and TW-01-30
2.5 mm for TW-01-20 and TW-01-15
3.0 mm for TW-01-25
3.0 mm for TW-01-30
®
T Automatic series offers you an automatic adjustment
®
T – Adjusting and Installation
®
®
T
T Automatic
1
2
3
4
1
2
3
4
www.igus.de/en/DryLinT
lateral guide:
–
+
less clearance
more clearance
vertical guide right
vertical guide left
unlocked
locked
61.11
mm