CM119 OWL, CM119 Datasheet - Page 8

• Manufacturer Part Number: CM119
• Description: ENERGY METER, WIRELESS
• Manufacturer: OWL

Specifications of CM119

• Colour: White
• External Depth: 30mm
• External Length / Height: 116mm
• External Width: 106mm
• Operating Temperature Max: 45°C
• Operating Temperature Min: 5°C
• Pack Quantity: 1
• Range: 30m
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

WHAT TO DO IF?
get your
to re-establish a communications link. This can be expedited by pressing and holding the <CHECK> key on the
Sender Unit until the Red LED flashes forcing the transmitter to transmit every 2 seconds.
NOTE
PROBLEM
No Display
“00.00”
displayed on
the monitor
“----” displayed
on the monitor
Wrong data is
appearing
Flashing “----”
displayed on
the monitor
Day/Month
in calendar
seems to be in
reverse
Remote
Monitor
reading
seems to be
High/Low
Wireless Energy Monitor should reach you in perfect condition. In the event that you are unable to get the
working correctly please follow the troubleshooting guide below to see if you can identify the problem and
After resetting the display it can take up to 2 minutes to complete a full search of available sender units or
working.
SYMPTOM
Nothing is displayed on
the screen
No Current Detected
Remote Monitor and
Sender Box are not
paired or have lost link
Remote Monitor may
have connected to
another Sender Box
within range
Automatic search
to find Sender Unit
underway
Remote Monitor setup
may be incorrect
Remote Monitor setup
may be incorrect
1. Ensure that batteries
2. Ensure that batteries
1. Check that sensor cable
2. Check that sensor is
1. Check that the correct
2. Check that the correct
Check This
Press and Hold the
<CHECK> key on
the Sender Box & the
<SEARCH> key on the
Remote Monitor to see
if the communication
link can be re-established
Remove Sensor cable
from Sender Box,
Remote Monitor should
show “00.00”.
Check that the
preferred date display
option has been
selected
are not exhausted
are inserted correctly
has been connected to
sender box
clipped around the
live wire
Tariff has been set.
voltage setting has
been selected.
7
-
1. Replace Batteries in Display
2. Refer to Quick Start Guide
1. Establish communications
2. If connected to sender unit
1. Enter the TARIFF setup
2. Enter the VOLT setup menu
REMEDY
Contact
Services
customer.services@theowl
com
Do Sensor search (Refer to
Quick Start Guide)
Allow search to run to
completion.
Enter the Date setup menu
and select preferred date
display (Refer to Quick
Start Guide)
to ensure batteries are
inserted correctly
link with Sender Box
following full reset (Refer
to Quick Start Guide)
check the set up of device
(Refer to Quick Start
Guide)
menu and adjust RATE
setting (Refer to Quick Start
Guide)
and select correct voltage
(Refer to Quick Start Guide)
Customer