ETU17 TIMEGUARD, ETU17 Datasheet - Page 7
![TIME SWITCH, PLUG-IN, 7DAY](/photos/23/84/238468/42267144_sml.jpg)
ETU17
Manufacturer Part Number
ETU17
Description
TIME SWITCH, PLUG-IN, 7DAY
Manufacturer
TIMEGUARD
Datasheet
1.ETU17.pdf
(11 pages)
Specifications of ETU17
Contact Type
ON/OFF
Time Range
7day
Contact Current Max
13A
External Depth
41mm
External Length / Height
81mm
External Width
60mm
Controller Output
Digital
Svhc
No SVHC (15-Dec-2010)
For Use With
Fluorescent Lighting, Filament Lighting, Motor
5
vi Repeat steps i to v to set the remainder of the 5 programme ON/OFF times and
4. Programme Review
To fast review the set programmes or for quick exit to normal operating mode - press
and hold down the <Program> button. Normal review can be carried out by pressing
the <Program> button briefly which reviews the clock time and day with the whole
display flashing. Further brief pressing of this button reviews the programme ON
and OFF times and day(s) in sequence again with the whole display flashing.
5. Making Changes to Clock Time and
This is required when making changes to the clock time/day or programme
times/days and can be initiated any time during the normal operating mode. Press the
<Program> button briefly and the clock symbol, day flag, hrs and minutes symbols on
the display will flash - this is programme review mode. Further brief pressing of the
<Program> button will display the ON and OFF programmes in sequence.
iii Press <Program> button briefly to select minutes -
iv Press <Program> button briefly - the first ON time
v Now set the hours and minutes as before. The
day(s) as required. Note: Any unused ON/OFF programmes must be left blank
and should be bypassed by pressing and holding down the <Programme> button
until the display shows normal operating mode. Do not programme ‘0’s into
unused programmes.
IMPORTANT After setting a clock time which falls within a programmed ON
period, the unit will not switch ON. Press the <Change> button to switch the
ETU17 ON (the ON will flash to indicate an override situation). After this the
unit will operate normally to the programmes set.
Programmes (Initiating Programme Mode)
display shows minute digits and ON flashing. Press
<Change> button to advance minute setting.
(Note: 16 hours shown as example of hours set).
is now set and display shows ready for the first OFF
programme time.
day(s) selected remains the same.
1 2 3 4 5 6 7
1 2 3 4 5 6 7
OFF
ON