GNICE JTAG Bluetechnix, GNICE JTAG Datasheet - Page 9
![no-image](/images/no-image-200.jpg)
GNICE JTAG
Manufacturer Part Number
GNICE JTAG
Description
EMULATOR, BLACKFIN, GNIC+ JTAG USB PROG
Manufacturer
Bluetechnix
Type
USB JTAG Emulatorr
Datasheet
1.GNICE_JTAG.pdf
(14 pages)
Specifications of GNICE JTAG
Supported Devices
Blackfin Processors
Core Sub-architecture
NO IMPORT
Ic Product Type
USB JTAG In-Circuit-Emulator
Features
USB 2.0 Full Speed, JTAG Clock (TCK) 6MHz, Link Status LED
Last update: 2010/08/23 18:16
The gnICE features four auxiliary signals routed to solder pads, located besides the Mini-USB Jack.
RX and TX are 3.3Volt TTL Signals they may not be connected to RS232 typical +/- 10V UART
signals
Utilizing the Serial Interface
The gnICE auxiliary Serial Interface can be used with the standard Linux ftdi_sio driver. In case your
kernel version already includes following patch, ignore this section. Otherwise it’s recommended
that your patch your HOST PC kernel with this patch.
gnICE gnICE+
It is also possible to utilize the Serial interface without this patch applied.
http://docs.blackfin.uclinux.org/
Label
RX
TX
GP
GND Signal Ground
Channel B (BDBUS1) RXD
Channel B (BDBUS0) TXD
Channel A (ACBUS2) GPIOH2
Description
UART RXD (3.3V IO) signal should connect to Blackfin TXD
UART TXD (3.3V IO) signal should connect to Blackfin RXD
This is a General Purpose IO Signal, which can be used to
RESET the board
In case the gnICE is connect to the board via the JATG header
this can be left unconnected
hw:jtag:gnice
http://docs.blackfin.uclinux.org/doku.php?id=hw:jtag:gnice
Note
Printed on 2010/10/15 04:21