702572 Spectrum Digital Inc, 702572 Datasheet - Page 32

no-image

702572

Manufacturer Part Number
702572
Description
XDS560R Target Adapter Cable For 14 Pin JTAG Header
Manufacturer
Spectrum Digital Inc
Datasheet

Specifications of 702572

Accessory Type
Target Adapter
Features
Compatible With XDS510USB PLUS / XDS560R From Spectrum Digital, Includes 14 Pin JTAG Header
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
For Use With
XDS510USB PLUS Or XDS560R USB JTAG Emulator
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Other names
Q5346474
Spectrum Digital, Inc
3.6 EMU0-EMU1 Signal Considerations
3-14
The EMU0-EMU1 signals are bi-directional multifunctional signals. These signals are
used for software benchmarking and software profiling.
On multi-processor systems, they can be used to assist in debugging by causing an
interrupt or breakpoint to occur from one device to another. These signals are used for
HS-RTDX (High-Speed Real Time Data eXchange).
HS-RTDX is a form of bi-directional data transfer.
Each EMU signal supports a single channel of data transfer.
This form of communication uses TCK and the EMU0 and/or EMU1 to achieve up to
2 Megabytes/second transfer rate. Also, the EMU0-EMU1 signals may be used to
select different modes of the device.
These modes are set when the device RESET signal is release, for normal emulation
the EMU0-EMU1 signal should be pulled high to the device Input/Output voltage.
For designs with target devices that don’t support HS-RTDX the only requirement is
that it is necessary to ensure that the EMU0-EMU1 lines can go from a logic low level
to a logic high level in less than 10 us. This can be calculated using the formula in
Equation 3-3:
Equation 3-3. Calculating EMU0-EMU1 Lines That Don’t Support HS-RTDX
For designs with target devices that support HS-RTDX, the requirements are the same
for a low number of devices. But as the number devices increases the response of the
EMU0-EMU1 signal will increase which will require the user to reduced the TCK
frequency.
To maximize the TCK rate, the user will be required to manually adjust the TCK
frequency and run the HS-RTDX confidence tests until a frequency is found where the
HS-RTDX confidence tests pass reliability.
It is suggested that after a frequency is found, that the user reduce the frequency by
additional 10% to guarantee that temperature and environmental changes don’t affect
the operation of the emulator.
For some multi-processor designs crossbar technology (CBT) devices could be used to
break the number of devices into a bank of devices.
t
r
= 5 (R
= 5(4.7KW x 16 15pf)
= 5.64 us.
pullup
x N
devices
x C
load_per_device
XDS560R JTAG Emulator Installation Guide
)

Related parts for 702572