DP-100 FR OFF-WHITE 3M, DP-100 FR OFF-WHITE Datasheet - Page 3

• Manufacturer Part Number: DP-100 FR OFF-WHITE
• Description: EPOXY 2 PART ADH, CART 1.7FL.OZ
• Manufacturer: 3M
• Series: Scotch-Weldr

Specifications of DP-100 FR OFF-WHITE

• Adhesive Type: Epoxy - 2 Part
• Color: Off White
• Weight: 1.7oz
• Volume: 50ml

3M
Epoxy Adhesive
DP-100 FR
Handling/Application
Information (continued)
™
Scotch-Weld
Surface Preparation
For high strength structural bonds, paint, oxide films, oils, dust, mold release agents
and all other surface contaminants must be completely removed. However, the
amount of surface preparation necessary depends on the required bond strength and
the environmental aging resistance desired by user.
The following cleaning methods are suggested for these common surfaces:
Steel:
1. Wipe free of dust with oil-free solvent such as acetone, isopropyl or alcohol
2. Sandblast or abrade using clean fine grit abrasives.
3. Wipe again with solvent to remove loose particles.
4. If a primer is used, it should be applied within 4 hours after surface preparation.
*When using solvents, extinguish all ignition sources, including pilot lights, and
Aluminum:
1. Alkaline Degrease: Oakite 164 solution (9-11 oz./gallon water) at 190°F (88°C)
2. Acid Etch: Place panels in the following solution for 10 minutes at 150°F (66°C)
3. Rinse: Rinse panels in clean running tap water.
4. Dry: Air dry 15 minutes; force dry 10 minutes at 190°F (88°C) ± 10°F (5°C).
5. If primer is to be used, it should be applied within 4 hours after surface
Plastics/Rubber
1. Wipe with isopropyl alcohol.*
2. Abrade using fine grit abrasives.
3. Wipe with isopropyl alcohol.*
*When using solvents, extinguish all ignition sources, including pilot lights, and
follow manufacturer’s precautions and directions for use.
follow manufacturer’s precautions and directions for use.
solvents.*
± 10°F (-13°C) for 10-20 minutes. Rinse immediately in large quantities of cold
running water.
± 5°F (-15°C).
preparation.
™
Sodium Dichromate
Sulfuric Acid, 66°Be
2024-T3 aluminum (dissolved)
Tap Water as needed to balance
Note: Read and follow component suppliers environmental, health and safety
recommendations prior to preparing this etch solution.
- 3 -
4.1-4.9 oz./gallon
38.5-41.5 oz./gallon
0.2 oz./gallon minimum