SNPF-S-TP-GY ITT Cannon, SNPF-S-TP-GY Datasheet - Page 8

• Manufacturer Part Number: SNPF-S-TP-GY
• Description: CONNECTOR, FEMALE, PANEL, GREY
• Manufacturer: ITT Cannon
• Series: Snaplockr

Specifications of SNPF-S-TP-GY

• Gender: Receptacle
• Voltage Rating: 415VAC
• Current Rating: 250A
• Connector Mounting: Panel
• Contact Termination: Screw
• Svhc: No SVHC (18-Jun-2010)
• Connector Type: Standard Power Entry
• Colour: Grey
• Rohs Compliant: Yes
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

www.ittcannon.com/powerlock
There are a wide range of cables used in the market to ensure that a
satisfactory result is obtained when POWERLOCK connectors are
terminated onto to the end of cables, the type and method needs to be
evaluated. For more details around termination, please refer to the
POWERLOCK Termination Guide which is available on
www.ittcannon.com.
The POWERLOCK Termination Guide provides guidelines on:
• how to perform a crimped termination
• what type of crimp tools and dies to use with recommendations
• how to perform a set screw termination
• terminating a threaded post panel type connector
• typical test results obtained when terminating connectors onto a
range of cables
There are two Line Source connectors for cable attachment, normally referred to as
a 400A and 660A version. Both are supplied with a male contact incorporating a
rigid IP2X finger proof nose, a slot for the secondary locking pin and a cable gland.
The contacts are secured in the housing by using a nylon cotter pin.
The 400A version has a set screw termination where two threaded set screws are
tightened to compress a reduction sleeve which has been fitted to the conductor
stranding. The set screw contact is normally used in combination with 120mm
cable. Smaller cable sections can be terminated by selecting the appropriate
reduction sleeves and sliding them on in sequence over the exposed conductor
stranding. In combination with these sleeves set screw contacts can handle cables
from 25mm
The 660A version has a crimp termination for cable cross sections from 35 mm
300mm
cable. It is essential to use the recommended crimp tool and die to ensure a
satisfactory crimp. Consult Customer Service for details on pull off loads and mV
drop values expected.
Line Source
400A, Earth Green
2
cable. The 660A contact is normally used in combination with 240mm
2
to 120mm
Line Source
2
.
8
Line Source
660A, Earth Green
Reliable connections for field installable
power distribution systems such as mobile
generators.
2
2
2
to