MCNL12KT561 MULTICOMP, MCNL12KT561 Datasheet - Page 14

• Manufacturer Part Number: MCNL12KT561
• Description: INDUCTOR, 560UH, 50MA, 10%, 3MHz
• Manufacturer: MULTICOMP

Specifications of MCNL12KT561

• Inductance Tolerance: ± 10%
• Dc Resistance Max: 30ohm
• Dc Current Rating: 50mA
• Self Resonant Frequency: 3MHz
• Core Material: Ferrite
• Inductor Case Style: 1812
• No. Of Pins: 2
• Inductance: 560µH
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

■Environmental Characteristics
Electrical Performance Test
Mechanical Performance Test
Climatic Test
Temperature Cycle
Damp Heat with Load
High Temperature
Storage
Low Temperature
Storage
Solderability
Resistance to Soldering
Heat
Vibration
Inductance
Q
SRF
DC Resistance DCR
Rated Current IDC
54
Storage Temperature: 25±3°C; Humidity < 80%RH
Item
Item
Item
Tel: [phone]
Refer to standard electrical
characteristic spec.
Appearance: No damage
L change: within±10%
Q change: within±30%
DCR: within specification
The electrodes shall be at least
90% covered with new solder
coating
Appearance: No damage
Appearance: No damage
L change: within±10%
Q change: within±30%
DCR: within specification
Requirement
Requirement
Requirement
Fax: [phone]
One cycle:
Total: 100 cycles
Measured after exposure in the room condition for 24 hrs
Temperature: 40±2°C
Relative Humidity: 90 ~ 95%
Time: 1000 hrs
Measured after exposure in the room condition for 24 hrs
Temperature: 85±3°C
Relative Humidity: 20%
Applied Current: Rated Current
Time: 1000 hrs
Measured after exposure in the room condition for 24 hrs
Temperature: -25±3°C
Relative Humidity: 0%
Time: 1000 hrs
Measured after exposure in the room condition for 24 hrs
Lead-free inductor: after fluxing(alpha 100 or equiv), inductor shall be
dipped in a melted solder bath at 245±5°C, 5±0.5 seconds
Pre-heating: 150°C, 1min.
Solder Temperature: 260±5°C
Immersion Time: 10±1 seconds
Test device shall be soldered on the substrate
Oscillation Frequency: 10 to 55 to 10Hz for 1 min.
Amplitude: 1.5 mm
Time: 2 hrs for each axis (X, Y&Z), total 6 hrs
HP4291 or HP4284
HP4291 or HP4284
HP4291
Agilent 34401A
Applied the current to coils, The inductance change should be less than
10% to initial value
Step
1
2
3
4
E-mail:
Temperature (°C)
-25±3
25±2
85±3
25±2
[e-mail]
Test Method
Test Method
Test Method
Time (min.)
30
30
3
3
http://www.viking.com.tw