B82801B504A50 EPCOS Inc, B82801B504A50 Datasheet - Page 8
![T3620 EE5 TRANSFORMER](/photos/10/9/100930/b82801b504a50_sml.jpg)
B82801B504A50
Manufacturer Part Number
B82801B504A50
Description
T3620 EE5 TRANSFORMER
Manufacturer
EPCOS Inc
Series
B82801Br
Datasheet
1.B82801B205A100.pdf
(9 pages)
Specifications of B82801B504A50
Turns Ratio - Primary:secondary
1 : 50
Inductance
500µH
Current Rating
20A
Dc Resistance (dcr)
0.8 mOhm Primary, 1.5 Ohm Secondary
Mounting Type
Surface Mount
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Transformer Type
-
E.t.
-
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Other names
495-4046-2
Please read Cautions and warnings and
Important notes at the end of this document.
Cautions and warnings
Please note the recommendations in our Inductors data book (latest edition) and in the data
sheets.
– Particular attention should be paid to the derating curves given there. Derating must be applied
– Ensure the operation temperature (which is the sum of the ambient temperature and the
– The soldering conditions should also be observed. Temperatures quoted in relation to wave
If the components are to be washed varnished it is necessary to check whether the washing
varnish agent that is used has a negative effect on the wire insulation, any plastics that are used,
or on glued joints. In particular, it is possible for washing varnish agent residues to have a
negative effect in the long-term on wire insulation.
The following points must be observed if the components are potted in customer applications:
– Many potting materials shrink as they harden. They therefore exert a pressure on the plastic
– It is necessary to check whether the potting material used attacks or destroys the wire
– The effect of the potting material can change the high-frequency behaviour of the components.
Ferrites are sensitive to direct impact. This can cause the core material to flake, or lead to
breakage of the core.
Even for customer-specific products, conclusive validation of the component in the circuit can
only be carried out by the customer.
in case the ambient temperature in the application exceeds the rated temperature of the
component.
temperature rise caused by losses / self-heating) of the component in the application does not
exceed the maximum value specified in the climatic category.
soldering refer to the pin, not the housing.
housing or core. This pressure can have a deleterious effect on electrical properties, and in
extreme cases can damage the core or plastic housing mechanically.
insulation, plastics or glue.
8
02/11