NT2S-SF126B-E Omron, NT2S-SF126B-E Datasheet - Page 23
![LCD Touch Panels 2x16LCD 8FKEY+NUMPAD 5VDC](/photos/21/26/212699/4608406_sml.jpg)
NT2S-SF126B-E
Manufacturer Part Number
NT2S-SF126B-E
Description
LCD Touch Panels 2x16LCD 8FKEY+NUMPAD 5VDC
Manufacturer
Omron
Datasheets
1.NT2S-CN222-V1.pdf
(6 pages)
2.NT2S-SF127B-E.pdf
(92 pages)
3.NT3S-ST126B-E.pdf
(214 pages)
Specifications of NT2S-SF126B-E
External Width
107mm
Supply Voltage Max
5VDC
External Depth
26mm
Ip/nema Rating
IP65
Mounting Type
Panel
External Height
107mm
Approval Bodies
CULus, CE
Rohs Compliant
Yes
No. Of Characters
2 X 16
No. Of Keys
20
Memory Size
24KB
Operating Temperature Range
0°C To +50°C
For Use With
Micro PLCs
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
2.1
NTXS series units should be mounted on a panel. Gasket and mounting clamps are provided with each
NTXS unit for proper mounting.
Environmental Considerations:
Make sure that the unit is installed correctly and that the environmental operating limits are followed (see
Specifications for NTXS).
Do not operate NTXS in areas subject to explosion hazards due to flammable gases, vapors or dusts.
NTXS should not be installed where fast temperature variations are present.
Location Considerations
Care should be taken when locating equipment behind the NTXS. Ensure that AC power wiring, PLC output
modules, contactors, starters, relays and any other source of electrical interference are located away from
NTXS.
Particular care should be taken to position Variable speed drives and switching power supplies away from
the NTXS .
Panel Mounting
Follow the procedure given below for proper mounting:
This section presents the dimensional sketches and panel cutouts for NTXS models.
1) Make a cutout of the required size. Panel cutout tolerance is + 0.1mm.
2) Put the gasket behind the bezel (see dimensional sketch for details).
3) Put the NTXS unit through the panel cutout.
4) Insert the clamps into the case.
5) Pullback the clamps until they seat into the retaining slots.
6) Tighten the clamping screws in an even pattern until the NTXS unit is secured into the
panel.
Installation Instructions
Page 18