NMTC-S16100XRGHS-10 Microtips Technology, NMTC-S16100XRGHS-10 Datasheet - Page 8
![LCD Character Display Modules Gray Reflective](/photos/15/61/156116/16x1__1__sml.jpg)
NMTC-S16100XRGHS-10
Manufacturer Part Number
NMTC-S16100XRGHS-10
Description
LCD Character Display Modules Gray Reflective
Manufacturer
Microtips Technology
Datasheet
1.NMTC-S16100XRGHS-10.pdf
(25 pages)
Specifications of NMTC-S16100XRGHS-10
Character Count X Line
16 x 1
Module Size (w X H X T)
80 mm x 36 mm x 10 mm
Fluid Type
STN
Background Color
Gray
Backlight Type
None
Display Mode
Reflective
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
INTERFACE PIN ASSIGNMENT
JUMPER EXPLANATION
1. JP2 and JP3 are both short: Pin15 is short with pin2 and pin16 is short with pin1. Backlight
2. JP2 short and JP3 open: Pin 15 is short with Pin2 and pin16 is NOT short with pin1. Backlight
3. JP2 open and JP3 short: Pin 15 is NOT short with pin 2 and pin16 is short with pin1. Backlight
4. JP2 and JP3 are both open: The backlight is fully independent with the logic, control the
5. J1 short: Bezel and screw holes connected to GND. J1 open: Bezel and screw holes floating
6. Never change the J2 and J3, it may burn off your system.
Note: J1, JP2 and JP3 are #0805 0 ohm resistors on the rear side of the PCB.
PIN NO.
14
15
16
powered up via V
and pin16.
is powered with V
connected to V
L or H.
is common VSS with logic and customer should keep pin16 floating or connected to GND
(V
backlight via pin15/pin16 or A/K.
1
2
3
4
5
6
7
|
SS
). Customer could control the backlight ON or OFF with pin15 H or L
PIN OUT
BKL1
BKL2
R/W
DB0
DB7
V
V
Vo
RS
E
DD
|
SS
DD
. Customer could control the backlight independently ON or OFF with pin16
DD
DD
Ground
Logic Circuit Power Supply
Power Supply For LCD Panel
Data/ Instruction Register Select
Read/ Write Select
Enable Signal
3-State I/O Data Bus
Power Supply for Backlight. See JUMPER EXPLANATION below.
100V/400Hz AC for EL, 4.2V or 120~180mA DC for LED backlight
Don’t care if no backlight
(pin2) and V
(same as logic circuit) and customer should keep pin 15 floating or
SS
(pin1). Customer does not need to supply power to pin15
8
DESCRIPTION