1490413-1 TE Connectivity, 1490413-1 Datasheet - Page 2

• Manufacturer Part Number: 1490413-1
• Description: Tools, Hydraulic Crimp
• Manufacturer: TE Connectivity
• Type: Dier

Specifications of 1490413-1

• Crimp Tool: Hydraulic Hand
• Connector Type: Crimp
• Rohs Compliant: NA
• Product: Tool Component
• Lead Free Status / RoHS Status: RoHS Not Applicable
• For Use With: Interchangeable Dies
• Lead Free Status / Rohs Status: RoHS Exempt Product

Reason for revision is given in Section 7, REVISION
SUMMARY.
2. DESCRIPTION
Each die assembly consists of a nest and an indenter
(ordered separately) which are retained in the
crimping head by retainer pins. The nest is positioned
in the yoke of the crimping head, and the indenter is
positioned in the ram of the tool.
3. DIE INSTALLATION AND REMOVAL
Refer to Figure 1 and determine the correct die
assembly, wire size, product number, and tool head to
be used together.
3.1. Die Installation
2 of 7
CAUTION
DANGER
Tools Using Crimping Dies for SOLISTRAND
Terminals and Splices (Refer to Figure 1)
NOTE
Hydraulic Head
1490747- - 1
i
!
All dimensions on this document are in metric
units [with U. S. customary units in brackets].
Figures and illustrations are for reference only
and are not drawn to scale.
Never operate the tool with the dies removed.
To avoid personal injury, be sure to exercise
extreme caution when using the power unit.
Avoid depressing the footswitch or trigger control
(Figure 3)
Hydraulic Head
1901821- - 1
Hydraulic Head
1901820- - 1
Tyco Electronics Corporation
Figure 2
3.2. Die Removal
1. Depress the upper die release button located in
the “C”--head.
2. Slide the nest into place in “C”--head. See
Figure 3.
3. Release the button and rock the die back and
forth until the nest snaps into position.
4. Activate the power unit until the lower die
release button located in the ram is exposed.
5. Depress the release button.
6. Slide the indenter into position in the ram. See
Figure 3.
7. Release the button and rock the indenter back
and forth until the die snaps into position.
8. Return ram to the down position.
1. Depress the upper release button located in the
“C”--head and slide the nest out of the head.
2. Activate the power unit until the lower die
release button (located in the ram) is exposed.
3. Depress the die release button and slide the
indenter out of the ram.
Hydraulic Hand
Tool 1490749- - 1
when installing or removing dies.
(Figure 3)
- -
- -
- -
- -
- -
- -
Hydraulic Hand
Tool 1490748- - 1
- -
- -
- -
CAUTION
WARNING
electrical lines.
Rev E