DLP-245SX DLP Design Inc, DLP-245SX Datasheet - Page 3
![Interface Modules & Development Tools USB/Micro Dev Board](/photos/26/87/268793/dlp245sx_sml.jpg)
DLP-245SX
Manufacturer Part Number
DLP-245SX
Description
Interface Modules & Development Tools USB/Micro Dev Board
Manufacturer
DLP Design Inc
Datasheet
1.DLP-245SX.pdf
(14 pages)
Specifications of DLP-245SX
Interface Type
USB
Data Bus Width
8 bit
Operating Supply Voltage
5.25 V
Product
Interface Modules
For Use With/related Products
SX28
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
GENERAL DESCRIPTION
The DLP-245SX provides a cost-effective, microcontroller-based method of interfacing an
electronic peripheral to a host computer via USB.
To send data from the peripheral to the host computer, the microcontroller simply writes the
byte-wide data into the FT245BM when TXE# is low. If the FT245BM’s transmit buffer fills up or
is busy storing the previously written byte, it will take its TXE# high in order to stop further data
from being written until some of the FIFO data has been transferred over USB to the host.
When the host sends data to the peripheral over USB, the FT245BM will take RXF# low to let the
microcontroller know that at least one byte of data is available. The microcontroller then reads
the data until RXF# goes high indicating that no more data is available to read.
By using FTDI’s virtual COM port drivers, the peripheral looks like a standard COM port to the
application software. Commands to set the baud rate are ignored--the FT245BM always
transfers data at its fastest rate (up to 3 megabits per second using VCP drivers, 7 mbps using
the DLL drivers) regardless of the application’s baud-rate setting. The latest versions of the
drivers are available for download from DLP Design’s website at http://www.dlpdesign.com.
DRIVER SOFTWARE
FTDI's VCP (virtual COM port) driver-executable files are provided royalty free on the condition
that they are used only with designs incorporating an FTDI device (i.e. the FT245BM and
DLP-245SX). The latest version of the drivers can be downloaded from dlpdesign.com or
ftdichip.com.
The VCP driver download file is a combined set of drivers for Windows 98, Windows ME, and
Windows 2000/XP. Unzip the file to a blank floppy disk or folder on your PC. (The drivers can
coexist on the same floppy disk or folder since the INF files determine which set of drivers to load
for each operating system version.) Once loaded, the VCP drivers allow your application
software running on the host PC to communicate with the DLP-245SX as though it were
connected to a COM (RS-232) port.
In addition to VCP drivers, FTDI's D2XX direct drivers for Windows offer an alternative solution to
the VCP drivers that allow application software to interface with the DLP-245SX using a DLL
3