ATDH40D240- Atmel, ATDH40D240- Datasheet - Page 5

• Manufacturer Part Number: ATDH40D240-
• Description: MCU, MPU & DSP Development Tools ADAPTER FOR AT40K EMULATION KIT
• Manufacturer: Atmel

Specifications of ATDH40D240-

• Interface Type: Parallel Port
• Operating Supply Voltage: 9 V
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

Programming the AT40K FPGA Device
When SW4 and SW5 are set to up, the PSLI device can be
programmed by the PC parallel interface. The ATDH40M
interfaces with the PC through the 10-pin header socket H1
located on the bottom right corner. Programming the FPGA
is not possible by using the parallel port interface on the
motherboard. Located below the header H1 are the mode-
select dip-switches DIP-SW1. These control the mode set-
tings for the PSLI device (switches M0, (M1), M2). The
modes directly supported by the motherboard are only
Slave Serial and Master Serial. Programming the AT40K
FPGA from the PC can be achieved from the IDS desktop
or by using the software downld40.exe. Both tools accept
ASCII bitstream files generated by the IDS software (.BST).
Programming the AT17 Configuration
Memory Device
When SW4 is set to down and SW5 is set to up, the AT17
FPGA configuration memory can be programmed by the
parallel port interface located on the top left corner.
Programming the AT17 FPGA Configuration EEPROM is
not possible by using the 10-pin header H1. Programming
the AT17 FPGA Configuration EEPROM from the PC can
be achieved from the IDS desktop or by using the Configu-
rator Programming System (CPS) software supplied by the
IDS software.This software accepts the ASCII bitstream
files (.BST) generated by IDS.
Programming the PSLI Device Using
the AT17 Configuration Memory
When SW4 is set to up and SW5 is set to down, the AT17
Configurator can program the FPGA in Master Serial. To
ensure reliable system power-up, set jumper JMP1
(located below the Configurator socket). The Configurator
must be programmed prior to this setup.
Troubleshooting
1. Check that the motherboard is connected to the PC
2. Check that the motherboard has power (SW1) and
3. Make sure programming configuration switches
4. Verify that the daughter card is inserted correctly
5. Verify that the PSLI device and/or the PSLI.
6. Set the mode switches before downloading to
7. Set the GCLK/FCLK jumpers before verifying
Technical Support
• Check each of the items listed in the troubleshooting
• Contact your local Atmel Representative or Distributor
• Contact your local Atmel FAE (available at most sales
• Contact the Atmel PSLI technical support hotline at (408)
• E-mail Atmel PSLI technical support at
• Fax inquiries to “FPGA Tech Support” at [phone]
section.
who provided the PSLI board for technical support.
offices).
436-4119. Hours are Monday-Friday 9:00 a.m. – 6:00
p.m. PST.
[e-mail] .
either through the parallel port or through the 10-pin
header.
the power configuration switches SW2 and SW3
are correct.
SW4 and SW5 are correct.
and that it receives power.
Configurator are placed in their sockets correctly.
the PSLI Device.
PSLI logic.
5