RK-WI.M900X Radiotronix, RK-WI.M900X Datasheet - Page 4

• Manufacturer Part Number: RK-WI.M900X
• Description: RF Modules & Development Tools Wi.M900X Kit
• Manufacturer: Radiotronix

Specifications of RK-WI.M900X

• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: RK-WIM900X

RK-Wi.M900X Rapid Development Kit
1 Description
The RK-Wi.M900X is a rapid-development/evaluation kit for the Wi.M900X data transceiver.
Included in the kit is:
2 RApid Development Kit Setup
© 2002-4 Radiotronix Inc, all rights reserved
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
1-Rapid Development Case.
1-Rapid Development Utility and Documentation CD.
2-Rapid Development Boards.
2-Wi.M900X Transceiver Modules, mounted on EVMs*.
2-900MHz antennas.
2-RS-232 cables.
2-USB cables.
6-AAA batteries.
Startup Guide.
An EVM is a Wi.M900X module pre-mounted on a small PCB with onboard antenna connector
and power supply regulator.
Insert the AAA batteries into the evaluation PCB, observing the correct polarity.
Insert an EVM into one of the evaluation boards, observing the correct orientation (see later in
this document). The correct orientation of the EVM is with the antenna connector closest to the
edge of the evaluation board. Make sure the module is seated fully and correctly.
Insert the other EVM into the other evaluation board, also observing the correct polarity.
Connect antennas to EVMs.
Connect evaluation boards to computers. If using USB communications, populate USB jumpers
and remove RS-232 jumpers. If using RS-232 communications, populate RS-232 jumpers and
remove USB jumpers.
Install the RK-Wi.M900X Windows software. If already installed, skip this step.
Run the RK-Wi.M900X software, select 2400 baud operation and navigate to the “Wireless Chat”
tab.
Power-On both evaluation boards, verifying that the version/copyright information is echoed to the
screen from both modules.
Chat back and forth between evaluation boards, verifying that serial and RF communications are
successful.
IMPORTANT NOTE FOR HYPERTERMINAL
- 3 -
USERS: See section 5.1
1/29/2007
User’s Manual