WI.M868X-EVM Radiotronix, WI.M868X-EVM Datasheet - Page 8

• Manufacturer Part Number: WI.M868X-EVM
• Description: RF Modules & Development Tools Wi.M868X-EVM Evaluation Module
• Manufacturer: Radiotronix

Specifications of WI.M868X-EVM

• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: WIM868X-EVM

RK-WI.M868X-R USER’S MANUAL
3. Using the RK-WI.M868X-R
The software supplied with the RK-Wi.M868X-R
volatile registers with the Wi.M868X-R
on the register settings.
3.1. COM Port Setup and Selection
Upon starting the RK-Wi.M868X-R
presented with a COM port selection dialog box. If you are using the USB
interface, make sure that the evaluation board is already connected to the
computer via the USB cable before you start the software. This will ensure
that the virtual COM port which is assigned to the USB to UART bridge
controller by Windows is visible in the COM port selection list.
The first time you start the RK-Wi.M868X-R
Rate should be left at 2400 baud, since this is the factory default baud rate
setting for the module.
Tip: The RK-Wi.M868X-R
baud rate of the module. If you have changed the Non-Volatile Data Rate
register, you will have to select the baud rate you set this register to when
you start the RK-Wi.M868X-R
3.2. Wireless Chat Page
The Wireless Chat page in the RK-Wi.M868X-R
Wi.232
with no register changes required, out of the box.
TM
to be used as a wireless communications link. The Rapid Development kit works as a wireless chat link
TM
TM
evaluation software does not auto detect the
evaluation software.
TM
TM
module. Refer to the Wi.M868X-R
evaluation software, you will be
TM
TM
evaluation software, the Baud
TM
TM
Development Kit is used to read and set the volatile and non-
evaluation software demonstrates the capability of the
Evaluation Software
7
TM
Users Manual for more information
Figure 1: COM Port Setup
Chapter
3