RK-WIM868X-DP-R Radiotronix, RK-WIM868X-DP-R Datasheet - Page 5

• Manufacturer Part Number: RK-WIM868X-DP-R
• Description: RF Modules & Development Tools DEVELOPMENT KIT FOR WIM868X-DP-R
• Manufacturer: Radiotronix

Specifications of RK-WIM868X-DP-R

• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

RK-Wi.M868X Rapid Development Kit
User’s Manual
3 Using the RK-Wi.M868X Evaluation Software
The software supplied with the RK-Wi.M868X RadKit is used to read and set the volatile and non-volatile
registers with the Wi.M868X module. Refer to the Wi.M868X Users Manual for more information on the
register settings.
3.1 COM Port Setup and Selection.
Upon starting the RK-Wi.M868X evaluation software, you will be
presented with a COM port selection dialog box. If you are using the
USB interface, make sure that the evaluation board is already
connected to the computer via the USB cable before you start the
software. This will ensure that the virtual COM port which is assigned
to the USB to UART bridge controller by Windows is visible in the
COM port selection list.
The first time you start the RK-Wi.M868X evaluation software, the
Baud Rate should be left at 2400 baud, since this is the factory default
baud rate setting for the module.
Tip: There is no way for the RK-Wi.M868X evaluation software to
detect which baud rate the module is set to. If you have changed the
Non-Volatile Data Rate register, you will have to select the baud rate
you set this register to when you start the RK-Wi.M868X evaluation
software.
- 4 -
1/29/2007
© 2002-4 Radiotronix Inc, all rights reserved