AD8310ARMZ-REEL7 Analog Devices Inc, AD8310ARMZ-REEL7 Datasheet - Page 13

• Manufacturer Part Number: AD8310ARMZ-REEL7
• Description: IC,Log/Antilog Amplifier,SINGLE,BIPOLAR,TSSOP,8PIN,PLASTIC
• Manufacturer: Analog Devices Inc
• Type: Logarithmic Amplifierr

Specifications of AD8310ARMZ-REEL7

• Applications: Receiver Signal Strength Indication (RSSI)
• Mounting Type: Surface Mount
• Package / Case: 8-MSOP, Micro8™, 8-uMAX, 8-uSOP,
• Number Of Channels: 1
• Number Of Elements: 6
• Power Supply Requirement: Single
• Input Resistance: 0.0012@5VMohm
• Single Supply Voltage (typ): 3/5V
• Dual Supply Voltage (typ): Not RequiredV
• Power Dissipation: 200mW
• Rail/rail I/o Type: Rail to Rail Input
• Single Supply Voltage (min): 2.7V
• Single Supply Voltage (max): 5.5V
• Dual Supply Voltage (min): Not RequiredV
• Dual Supply Voltage (max): Not RequiredV
• Operating Temp Range: -40C to 85C
• Operating Temperature Classification: Industrial
• Mounting: Surface Mount
• Pin Count: 8
• Package Type: MSOP
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

For zero-signal conditions, all the detector output currents are
equal. For a finite input of either polarity, their difference is
converted by the output interface to a single-sided unipolar
current, nominally scaled 2 μA/dB (40 μA/decade), at the
output pin BFIN. An on-chip resistor of ~3 kΩ, R1, converts
this current to a voltage of 6 mV/dB. This is then amplified by a
factor of 4 in the output buffer, which can drive a current of up
to 25 mA in a grounded load resistor. The overall rise time of
the AD8310 is less than 15 ns. There is also a delay time of
about 6 ns when the log amp is driven by an RF burst, starting
at zero amplitude.
Rev. F | Page 13 of 24
When driving capacitive loads, it is desirable to add a low value
of load resistor to speed up the return to the baseline; the buffer
is stable for loads of a least 100 pF. The output bandwidth can
be lowered by adding a grounded capacitor at BFIN. The time-
constant of the resulting single-pole filter is formed with the
3 kΩ internal load resistor (with a tolerance of 20%). Therefore,
to set the −3 dB frequency to 20 kHz, use a capacitor of 2.7 nF.
Using 2.7 μF, the filter corner is at 20 Hz.
AD8310