CS4207-CNZ Cirrus Logic Inc, CS4207-CNZ Datasheet - Page 27

• Manufacturer Part Number: CS4207-CNZ
• Description: IC Low Pwr,4/6 HD Aud Codec W/HP Amp
• Manufacturer: Cirrus Logic Inc
• Type: Audio Codecr

Specifications of CS4207-CNZ

• Resolution (bits): 24 b
• Number Of Adcs / Dacs: 2 / 3
• Sigma Delta: Yes
• Dynamic Range, Adcs / Dacs (db) Typ: 105 / 110
• Voltage - Supply, Analog: 2.97 V ~ 5.25 V
• Voltage - Supply, Digital: 2.97 V ~ 5.25 V
• Operating Temperature: -40°C ~ 85°C
• Mounting Type: Surface Mount
• Package / Case: 48-QFN
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 598-1796

DS880F1
4.6
Power State Settings Reset (PS-SettingsReset)
PS-SettingsReset is reported as set to one ‘1’b when, during any low power state transition the settings that
were changed from the defaults (either through software or hardware) have been reset back to their default
state. When these settings have not been reset, this is reported as ‘0’b. The conditions that may reset set-
tings to their defaults are:
1. Power On; always sets the PS-SettingsReset to ‘1’b for all widgets that report EPSS set to ‘1’b and that
2. Double Function Group Reset: sets PS-SettingsReset to ‘1’b for all widgets that report EPSS set to one
Single Function Group Reset, Link Reset or BITCLK stopped will not cause the PS-SettingsReset bit to be
set to ‘1’b. All settings should persist across these events.
The PS-SettingsReset will be reported at the individual widget level and at the Audio Function Group level.
The PS-SettingsReset bit for the Audio Function Group is handled differently than at the widget level. For
the Audio Function Group the PS-SettingsReset bit is set to ‘1’b when any widget sets its PS-SettingsReset
to ‘1’b. The Audio Function Group’s PS-SettingsReset bit is the logical “or” of all the PS-SettingsReset bits,
but is latched so that it can be reset independently and not require all the individual widget PS-SettingsReset
bits be reset. This allows a simple poll by the host software to detect when some settings have been re-
set/changed. For widgets that do not support the EPSS bit, reporting PS-SettingsReset is not required.
If the PS-SettingsReset bit is set to ‘1’b, then this bit for individual widgets, will be cleared to ‘0’b on receipt
of any “Set” verb to that widget; or after responding to a “Get” Power State verb, to that widget.
Bit settings within converters and pin widgets that software changed from their defaults will not be changed
by hardware across any Dx state transition, single function group resets or link resets.
outlines the handling of setting persistence should be performed across Dx states, clock stopping and re-
sets. Because the CS4207 supports EPSS, the use of PS-SettingsReset to report that settings have been
reset (changed) is required.
have host programmable settings and reset all settings.
(1) and that have host programmable settings and resets all settings.
Power On Reset or
Double Function
Group Reset
Get “Power State”
‘1’b
Verb
CLK
D
CLR
Q
Q
PS_Settings Reset Bit
Function Group
Table 1 on page 28
CS4207
27