CS5361-KSZR Cirrus Logic Inc, CS5361-KSZR Datasheet - Page 20
![no-image](/images/manufacturer_photos/0/1/141/cirrus_logic_inc_sml.jpg)
CS5361-KSZR
Manufacturer Part Number
CS5361-KSZR
Description
IC,A/D CONVERTER,DUAL,24-BIT,SOP,24PIN
Manufacturer
Cirrus Logic Inc
Datasheet
1.CS5361-KZZ.pdf
(23 pages)
Specifications of CS5361-KSZR
Number Of Bits
24
Sampling Rate (per Second)
204k
Data Interface
Serial
Number Of Converters
2
Power Dissipation (max)
235mW
Voltage Supply Source
Analog and Digital
Operating Temperature
-10°C ~ 70°C
Mounting Type
Surface Mount
Package / Case
24-SOIC (0.300", 7.50mm Width)
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
For Use With
598-1547 - BOARD EVAL FOR CS5361 STEREO ADC
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
5.0 PARAMETER DEFINITIONS
Dynamic Range
Total Harmonic Distortion + Noise
Frequency Response
Interchannel Isolation
Interchannel Gain Mismatch
Gain Error
Gain Drift
Offset Error
20
The ratio of the rms value of the signal to the rms sum of all other spectral components over the specified
bandwidth. Dynamic Range is a signal-to-noise ratio measurement over the specified bandwidth made
with a -60 dBFS signal. 60 dB is added to resulting measurement to refer the measurement to full-scale.
This technique ensures that the distortion components are below the noise level and do not affect the
measurement. This measurement technique has been accepted by the Audio Engineering Society,
AES17-1991, and the Electronic Industries Association of Japan, EIAJ CP-307. Expressed in decibels.
The ratio of the rms value of the signal to the rms sum of all other spectral components over the specified
bandwidth (typically 10 Hz to 20 kHz), including distortion components. Expressed in decibels. Measured
at -1 and -20 dBFS as suggested in AES17-1991 Annex A.
A measure of the amplitude response variation from 10 Hz to 20 kHz relative to the amplitude response
at 1 kHz. Units in decibels.
A measure of crosstalk between the left and right channels. Measured for each channel at the converter's
output with no signal to the input under test and a full-scale signal applied to the other channel. Units in
decibels.
The gain difference between left and right channels. Units in decibels.
The deviation from the nominal full-scale analog output for a full-scale digital input.
The change in gain value with temperature. Units in ppm/°C.
The deviation of the mid-scale transition (111...111 to 000...000) from the ideal. Units in mV.
CS5361
DS467F2