DSPIC33FJ16GP304T-I/PT Microchip Technology, DSPIC33FJ16GP304T-I/PT Datasheet
DSPIC33FJ16GP304T-I/PT
Specifications of DSPIC33FJ16GP304T-I/PT
Available stocks
Related parts for DSPIC33FJ16GP304T-I/PT
DSPIC33FJ16GP304T-I/PT Summary of contents
Page 1
... The Device and Revision IDs (DEVID and DEVREV) are located at the last two implemented addresses in program memory. 2: Refer to the “dsPIC33F/PIC24H Flash Programming Specification” (DS70152) for detailed information on Device and Revision IDs for your specific device. © 2010 Microchip Technology Inc. dsPIC33FJ32GP202/204 and dsPIC33FJ16GP304 and For example, to identify the silicon revision level using MPLAB IDE in conjunction with MPLAB ICD 2 or PICkit™ ...
Page 2
... PSV page. 2 When the I C module is configured as a 10-bit slave with an address of 0x102, the I2CxRCV register content for the lower address byte is 0x01 rather than 0x02. Affected (1) Revisions © 2010 Microchip Technology Inc. ...
Page 3
... All 150ºC 24. Operation Note 1: Only those issues indicated in the last column apply to the current silicon revision. © 2010 Microchip Technology Inc. Issue Summary 2 With the I C module enabled, the PORT bits and external Interrupt Input functions (if any) associated with SCL and SDA pins will not reflect the actual digital logic levels on the pins ...
Page 4
... BCLK pin is present only when the module is transmitting. The pin is idle at all other times. Work around Configure one of the output compare modules to generate the required baud clock signal when the UART is receiving data Idle state. Affected Silicon Revisions © 2010 Microchip Technology Inc. ...
Page 5
... © 2010 Microchip Technology Inc. 2 10. Module there are two I C devices on the bus, one of them is acting as the Master receiver and the other as the Slave transmitter. Suppose that both devices are configured for 10-bit addressing mode, and have the same value in the A10 and A9 bits of their addresses ...
Page 6
... When the I C module is configured as a 10-bit slave with and address of 0x102, the I2CxRCV register content for the lower address byte is 0x01 rather than 0x02; however, acknowledges both address bytes. Work around None. Affected Silicon Revisions © 2010 Microchip Technology Inc. the module ...
Page 7
... Affected Silicon Revisions © 2010 Microchip Technology Inc. 19. Module: I When the I (if any) or Slave mode, after the ACKSTAT bit is set when receiving a NACK, it may be cleared by the reception of a Start or Stop bit. Work around Store the value of the ACKSTAT bit immediately after receiving a NACK. ...
Page 8
... The ADC module must be reinitialized by the user application before resuming ADC operation. Example 1. Unlike Work around 1, the user application does not need to reinitialize the ADC module; however necessary to re-enable the ADC module by setting the ADON bit after waking from Sleep © 2010 Microchip Technology Inc. #0 ...
Page 9
... Module: All The affected silicon revisions listed below are not warranted for operation at 150ºC. Work around Only use the affected revisions of silicon for Hi-Temp operating range from -40ºC to +140ºC. Affected Silicon Revisions © 2010 Microchip Technology Inc. DS80460E-page 9 ...
Page 10
... T Operating temperature -40°C ≤ T Min Typ Max Units V — 0 — 0.8 SS 0.7 V — 5.5 DD 2.1 — 5.5 ≤ +85°C for Industrial A ≤+125°C for Extended A Conditions V SMBus disabled V SMBus enabled V SMBus disabled V SMBus enabled © 2010 Microchip Technology Inc. ...
Page 11
... Added silicon issue 23 (ADC) and data sheet clarification 1 (DC Characteristics: I/O Pin Input Specifications). Rev D Document (10/2010) Updated the work around in silicon issue 23 (ADC). Added silicon issue 24 (All). Rev E Document (12/2010) Added silicon revision A6 references throughout the document. © 2010 Microchip Technology Inc. Operations), 16- and DS80460E-page 11 ...
Page 12
... NOTES: DS80460E-page 12 © 2010 Microchip Technology Inc. ...
Page 13
... PICtail, REAL ICE, rfLAB, Select Mode, Total Endurance, TSHARC, UniWinDriver, WiperLock and ZENA are trademarks of Microchip Technology Incorporated in the U.S.A. and other countries. SQTP is a service mark of Microchip Technology Incorporated in the U.S.A. All other trademarks mentioned herein are property of their respective companies. ...
Page 14
... Philippines - Manila Tel: 63-2-634-9065 Fax: 63-2-634-9069 Singapore Tel: 65-6334-8870 Fax: 65-6334-8850 Taiwan - Hsin Chu Tel: 886-3-6578-300 Fax: 886-3-6578-370 Taiwan - Kaohsiung Tel: 886-7-213-7830 Fax: 886-7-330-9305 Taiwan - Taipei Tel: 886-2-2500-6610 Fax: 886-2-2508-0102 Thailand - Bangkok Tel: 66-2-694-1351 Fax: 66-2-694-1350 © 2010 Microchip Technology Inc. 08/04/10 ...