EPM7160SQC160-7 Altera, EPM7160SQC160-7 Datasheet - Page 17
![no-image](/images/manufacturer_photos/0/0/40/altera_sml.jpg)
EPM7160SQC160-7
Manufacturer Part Number
EPM7160SQC160-7
Description
MAX 7000/S/AE/B
Manufacturer
Altera
Datasheet
1.EPM7160EQC100-15.pdf
(62 pages)
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Altera Corporation
Programmable
Speed/Power
Control
Output
Configuration
f
For more information on using the Jam language, see
(Using the Jam Language for ISP & ICR via an Embedded
The ISP circuitry in MAX 7000S devices is compatible with IEEE Std. 1532
specification. The IEEE Std. 1532 is a standard developed to allow
concurrent ISP between multiple PLD vendors.
MAX 7000 devices offer a power-saving mode that supports low-power
operation across user-defined signal paths or the entire device. This
feature allows total power dissipation to be reduced by 50% or more,
because most logic applications require only a small fraction of all gates to
operate at maximum frequency.
The designer can program each individual macrocell in a MAX 7000
device for either high-speed (i.e., with the Turbo Bit
or low-power (i.e., with the Turbo Bit option turned off) operation. As a
result, speed-critical paths in the design can run at high speed, while the
remaining paths can operate at reduced power. Macrocells that run at low
power incur a nominal timing delay adder (t
t
MAX 7000 device outputs can be programmed to meet a variety of
system-level requirements.
MultiVolt I/O Interface
MAX 7000 devices—except 44-pin devices—support the MultiVolt I/O
interface feature, which allows MAX 7000 devices to interface with
systems that have differing supply voltages. The 5.0-V devices in all
packages can be set for 3.3-V or 5.0-V I/O pin operation. These devices
have one set of VCC pins for internal operation and input buffers
(VCCINT), and another set for I/O output drivers (VCCIO).
The VCCINT pins must always be connected to a 5.0-V power supply.
With a 5.0-V V
are therefore compatible with both 3.3-V and 5.0-V inputs.
The VCCIO pins can be connected to either a 3.3-V or a 5.0-V power
supply, depending on the output requirements. When the VCCIO pins are
connected to a 5.0-V supply, the output levels are compatible with 5.0-V
systems. When V
3.3 V and is therefore compatible with 3.3-V or 5.0-V systems. Devices
operating with V
timing delay of t
EN
, and t
SEXP
, t
CCINT
ACL
OD2
CCIO
CCIO
MAX 7000 Programmable Logic Device Family Data Sheet
, and t
level, input voltage thresholds are at TTL levels, and
instead of t
levels lower than 4.75 V incur a nominally greater
is connected to a 3.3-V supply, the output high is
CPPW
OD1
parameters.
.
LPA
) for the t
TM
Application Note 88
Processor).
option turned on)
LAD
, t
LAC
, t
IC
,
17