MTCBA-C-N12-NAM Multi-Tech Systems, MTCBA-C-N12-NAM Datasheet - Page 12
![MODEM CDMA US BUNDLE IP](/photos/27/2/270202/mtcba-c-n12-nam_sml.jpg)
MTCBA-C-N12-NAM
Manufacturer Part Number
MTCBA-C-N12-NAM
Description
MODEM CDMA US BUNDLE IP
Manufacturer
Multi-Tech Systems
Specifications of MTCBA-C-N12-NAM
Function
Transceiver, CDMA, Modem
Modulation Or Protocol
CDMA2000
Frequency
800MHz, 1.9GHz
Interface
RS-232
Data Rate - Maximum
153.6 kbps
Voltage - Supply
5 V ~ 32 V
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Other names
881-1025
Optional – Attach the Modem to a Flat
Surface
Multi-Tech Systems, Inc. MultiModem CDMA Wireless Modem User Guide
To mount the Wireless MultiModem, do the following:
For optional direct-DC powering.
1.
2.
3.
4.
Typically, the unit is mounted against a flat surface into which holes can be drilled. The mounting holes
Slide the mounting bridle into the corresponding slots on the backside of the modem chassis.
Attach the modem with two screws to the mounting surface at the desired location on the equipment.
•
•
Warning
Obtain mounting screws (two are needed) that are appropriate for the surface on which you will mount the
modem. For example, one might use two 6-32 self-tapping screws 5/8” in length to mount the unit in a
truck to the wall of the cab behind the passenger’s seat.
(center-to-center) must be separated by 125mm or 4 -15/16 inches.
Drill the mounting holes at the desired mounting location.
Note:
Note:
Connect the direct-DC power supply cable into the DC power source on the vehicle or machine in
which you are mounting the modem. Be sure the GND connection is correct.
Connect red wire to + (positive) and black wire to – (negative).
Over-voltage protection is provided on the device. To ensure complete protection, you
may want to add additional filtering to the DC input
locations.
For automotive application: according to the type of application, you can use permanent “+” or key-
switched “+”. Connect the power supply to its source (for example, in a mobile situation, to the
vehicle’s DC fuse/terminal block).
Units shipped with the universal AC power supply are not suited for installation in hazardous
Chapter 2 – Activation and Installation
12