MTCBA-C-N12-NAM Multi-Tech Systems, MTCBA-C-N12-NAM Datasheet - Page 4

• Manufacturer Part Number: MTCBA-C-N12-NAM
• Description: MODEM CDMA US BUNDLE IP
• Manufacturer: Multi-Tech Systems

Specifications of MTCBA-C-N12-NAM

• Function: Transceiver, CDMA, Modem
• Modulation Or Protocol: CDMA2000
• Frequency: 800MHz, 1.9GHz
• Interface: RS-232
• Data Rate - Maximum: 153.6 kbps
• Voltage - Supply: 5 V ~ 32 V
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 881-1025

MultiModem CDMA Wireless Modem
Hazardous Locations Installation Instructions
Vehicle Safety
4
•
•
•
•
•
Operation of the MultiModem in the vicinity of other electronic
1.
2.
3.
4.
5.
6.
Do not use your Wireless MultiModem while driving, unless
Respect national regulations on the use of cellular telephones
If incorrectly installed in a vehicle, the operation of Wireless
The use of an alert device to operate a vehicle’s lights or horn
equipment may cause interference if the equipment is
inadequately protected. Observe any warning signs and
manufacturers’ recommendations.
equipped with a correctly installed vehicle kit allowing ‘Hands-
Free’ Operation.
in vehicles. Road safety always comes first.
MultiModem telephone could interfere with the correct
functioning of vehicle electronics. To avoid such problems, be
sure that qualified personnel have performed the installation.
Verification of the protection of vehicle electronics should be
part of the installation.
on public roads is not permitted.
The modems are open devices intended for installation in
an ultimate enclosure suitable for the intended application.
THIS EQUIPMENT IS SUITABLE FOR USE IN CLASS I,
DIVISION 2, GROUPS A, B, C, AND D OR NON-
HAZARDOUS LOCATIONS ONLY.
“WARNING – Explosion Hazard – Substitution of
Components may Impair Suitability for Class I, Division 2”.
“WARNING – Explosion Hazard – Do not Disconnect
Equipment Unless Power has been switched off or the
area is known to be Non-hazardous”.
“WARNING – Explosion Hazard – Do not replace fuse
unless power has been switched off or the area is known
to be non-hazardous”
“WARNING – Do not install or remove SIM card unless
power has been switched off or the area is known to be
non-hazardous”.
Multi-Tech Systems, Inc. Quick Start Guide