AL6H-A24-Y IDEC, AL6H-A24-Y Datasheet - Page 13

• Manufacturer Part Number: AL6H-A24-Y
• Description: AL6H-A24-Y RCT LED PB DPDT IP4
• Manufacturer: IDEC

Specifications of AL6H-A24-Y

• Contact Configuration: DPDT
• Switch Operation: On-Off
• Contact Voltage Ac Nom: 240V
• Contact Voltage Dc Nom: 120V
• Contact Current Max: 1A
• Actuator Style: Rectangular

Marking Plates for Pushbuttons with Standard Size Lens
Marking Plates for Pushbutton with Oversize Lens
Replacing Lens and Marking Plate
Removal
Remove the lens holder assembly (lens, marking plate and holder) from the
operator by holding the color lens recesses with the lens removal tool (Part
No.MT-101) and pulling out. Remove marking plate by pushing the color lens
from the rear to disengage the latches. Marking plate must be engraved on
the side as shown in the figure on the right.
Installation
For illuminated and non-illuminated pushbuttons:
1. Insert marking plate inside lens in correct direction
2. Press color lens on to lens holder to engage latches.
3. Insert lens holder into housing in correct direction.
www.idec.com
Style
Dimensions
Outside (OD)
Marking Area (a)
Style
Dimensions
Outside (OD)
Marking Area (a)
(For non-illuminated, install marking plate when replacing button).
Do not loosen spring on illuminated pushbutton units
(except on pilot light units). The marking plate must
be engraved on the front side as shown above.
Engraving must be made on the engraving area within 0.02" (0.5mm) deep.
Miniature Switches & Pilot Devices
Round—AL6M-W
Ø 0.538"
(13.8mm)
Ø 0.468"
(12mm)
Round—AL6M-MW
Ø 0.491" (12.6mm)
Ø 0.429" (11mm)
Ø a
Ø a
Ø OD
Marking
Area
USA: (800) 262-IDEC or [phone], Canada: (888) 317-IDEC
Ø OD
Marking
Area
Ø 5/8" (16mm)
Square—AL6Q-W
(13.8mm)
(12mm)
OD
0.538"
0.468"
Dimensions con’t
Square/Rectangular—AL6Q-QW
0.491" (12.6mm)
0.429" (11mm)
Marking
Area
a
OD
OD
Rectangular—AL6H-W
0.538" x 0.772"
(13.8 x 19.8mm)
0.468" x 0.702"
(12 x 18mm)
1
Ø 5/8" (16mm)
Color
Lens
Recess
OD
Marking
Area
a
Engraving
a
2
Area
2
Latches
Marking
Area
Marking
a
Plate
1
Lens
Holder
ø16mm - A6 Series
Operator
A2-29
A2