SNDJ-H3C-G02 Honeywell Sensing and Control, SNDJ-H3C-G02 Datasheet - Page 2

• Manufacturer Part Number: SNDJ-H3C-G02
• Description: ZERO SPEED HALL SENSOR
• Manufacturer: Honeywell Sensing and Control
• Series: SNDJr
• Type: Hall Effectr

Specifications of SNDJ-H3C-G02

• Output Type: Digital
• Actuator Material: Ferrous Metals, Gear Tooth
• Termination Style: Connector
• Frequency: 15kHz
• Voltage - Supply: 8 V ~ 25 V
• Must Operate: *
• Must Release: *
• Function: *
• Package / Case: Barrel, Stainless Steel
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 480-2812

SNDJ-H3*-G0*Series
SENSOR SPECIFICATIONS
Characteristic
Supply voltage
Current consumption
Signal outputs
Frequency range
Insulation
Operating temperature
Housing
Cable/connector
Protection class
Vibration immunity
Shock immunity
Weight
Air gap
Pole wheel
NOTICE
INSTALLATION INFORMATION
•
•
•
2
The sensor wires must be laid as far as possible from
large electrical machines. They must not run parallel with
power cables. The maximum permissible cable length is
20 m [65 ft].
Using radial or axial mounting, the sensor should be
mounted with the center of the sensor face over the center
of the gear teeth or targets. Using radial sensor mounting,
some axial movement is permissible.
A solid and vibration-free mounting of the sensor is
important.
www.honeywell.com/sensing
Parameter
8 Vdc to 25 Vdc
10 mA max. (without load)
Square wave signal from NPN output transistor with 2.7 kOhm pull-up, dc-coupled to the supply
(negative pole = reference voltage)
25 mA max. load
Output voltage HI: power supply voltage
Output voltage LO: <0.5 Volt @ I = 25 mA
0 Hz to 15 kHz
Housing and electronics are galvanically isolated (500 V/50 Hz/1 min.)
-20 °C to 100 °C [-4 °F to 212 °F]
Stainless steel 1.4305. Dimensions per drawings.
L version: PUR cable, three conductor 0.34 mm
C version: Euro M12 thread 4-pin connector
Sensor head IP68, cable/entrance IP67, connector IP68 (mated)
30 g in the range 5 Hz to 2000 Hz
50 g during 20 ms, half-sine wave
L version: ~120 g, including 1 m [39.37 in] cable
C version: ~80 g
For pole wheel M1 (DP 25,4): 0,3 mm to 0,5 mm [0.012 in to 0.02 in]
For pole wheel M2 (DP 12,7): 0,3 mm to 1,5 mm [0.012 in to 0.06 in]
Ferromagnetic toothed wheel, i.e. B. USt37-2, type 1018 CRS, preferred involute gear form
Module >(DP 25.4 [1.0 in]), min. tooth width 6 mm [0.24 in], side offset with min. tooth width:
<0,2 mm [0.008 in]
2
[0.013 in
2
](AWG 22)