A3AT-90L1-00EG Omron, A3AT-90L1-00EG Datasheet - Page 9

• Manufacturer Part Number: A3AT-90L1-00EG
• Description: ASSY.L.P.B.INCLD.FLANGE/SPRING
• Manufacturer: Omron
• Series: A3Ar
• Type: Illuminatedr

Specifications of A3AT-90L1-00EG

• Circuit: SPST-NO
• Switch Function: Off-On
• Contact Rating @ Voltage: 6A @ 125VAC
• Actuator Type: Round Button
• Illumination Type, Color: LED, Green
• Illumination Voltage (nominal): 2.1 VDC
• Mounting Type: Panel Mount
• Termination Style: Solder Lug
• Current Rating (max): 6 Amps
• Voltage Rating Ac: 250 volts
• Voltage Rating Dc: 30 Volts
• Contact Configuration: SPST-NO
• Contact Voltage Ac Nom: 250V
• Contact Voltage Dc Nom: 250V
• Contact Current Max: 6A
• Actuator Style: Round
• Actuator / Cap Colour: Green
• Illumination Colour: Green
• Svhc: No
• Rohs Compliant: Yes
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: A3AT90L100EG

A3A
Installation
Mounting Switch Unit on a Panel
Mount Leaf Spring
Press the leaf spring into the fitted groove on the upper surface of
the switch unit. For an easier fitting, first fit one side of the leaf spring,
then press the other side into the fitting groove.
Note: Be sure to fit the leaf spring exactly into the groove, and do
Mount Flange on Panel
Insert the flange from the front surface of the panel.
The flange has two opposing guides to facilitate its insertion into the
panel cutout hole. Be sure the flange does not remain tilted with re-
spect to the panel surface after being installed.
Note: The mounting direction of the flange determines the
Fit Flange with Switch Unit
While holding the flange, insert the opposing supports into the gaps
between the leaf spring and switch unit on the longer sides of the
housing, and fit the rectangular hole of the flange with the projec-
tions of the switch housing.
Note: Completely remove any burrs on the panel cutout surface;
Cross Section
not allow it to slip out of the groove.
orientation of the switch unit.
otherwise, the flange and switch unit will not attach solidly.
Panel
Panel (t = 1 to 1.6 mm)
Flange
Flange
Leaf spring
fitting groove
Switch unit
Leaf spring
Guide
Projection
Support
Panel
Removing Switch Unit
Insert a small flat-bladed screwdriver or tweezers into the flange
support exposed on the rear of the panel. Pry up on each side to pull
out the switch unit.
Note: Do not pry up the flange support more than necessary or
the switch holding portions may be damaged.
Panel
Flat-bladed screwdriver
or tweezers
A3A
9