0638112400 Molex Inc, 0638112400 Datasheet - Page 3

• Manufacturer Part Number: 0638112400
• Manufacturer: Molex Inc
• Type: Hand Crimp Toolr

Specifications of 0638112400

• Lead Free Status / RoHS Status: RoHS Not Applicable

Hand Crimp Tool for 1.50mm (.591") Pitch, MX150
Doc No: ATS-638112400
Revision: C
5. Close the tool until the ratchet releases.
6. Lift the wire stop blades up.
7. Carefully remove the crimped terminal.
Maintenance
It is recommended that each operator of the tool be
made aware of, and responsible for, the following
maintenance steps:
1. Remove dust, moisture, and other contaminants
2. Do not use any abrasive materials that could
3. Make certain all pins; pivot points and bearing
4. When tool is not in use, keep the handles
Miscrimps or Jams
Should this tool ever become stuck or jammed in a partially closed position,
closed.
Warranty
This tool is for electrical terminal crimping purposes only. This tool is made of the best quality materials. All vital
components are long life tested. All tools are warranted to be free of manufacturing defects for a period of 30
days. Should such a defect occur, we will repair or exchange the tool free of charge. This repair or exchange will
not be applicable to altered, misused, or damaged tools. This tool is designed for hand use only. Any clamping,
fixturing, or use of handle extensions voids this warranty.
Note: To maintain a good brush control and a consistent bell mouth the crimping instructions must be
followed.
with a clean brush, or soft, lint free cloth.
damage the tool.
surfaces are protected with a thin coat of high
quality machine oil. Do not oil excessively.
closed to prevent objects from becoming lodged
in the crimping dies, and store the tool in a
clean, dry area.
The tool will open easily by pushing the ratchet release lever.
CAUTION: Molex crimp specifications are valid only when used with Molex terminals and tooling.
(See Figure 3)
Release Date: 01-21-03
Revision Date: 04-23-08

Blade Crimp Terminals
LOCATOR
WIRE STOP
UNCONTROLLED COPY
BLADES
TERMINAL
Figure 2
RETAINER
Do Not force the handles open or
CONDUCTOR
ANVIL
SPACER
INSULATION
CONDUCTOR
ANVIL
INSULATION
PUNCH
Page 3 of 5
PUNCH
WIRE