0638114900 Molex Inc, 0638114900 Datasheet - Page 3

• Manufacturer Part Number: 0638114900
• Manufacturer: Molex Inc
• Type: Hand Crimp Toolr

Specifications of 0638114900

• Lead Free Status / RoHS Status: RoHS Not Applicable

Hand Crimp Tool for 2.54mm (.100") Pitch MX64™ GET Terminals
Doc No: ATS-638114900
Revision: B
4. Slide the pre-stripped wire into the terminal; make sure to aim the wire brush towards the tip point on the
5. Close the tool until the ratchet releases.
6. Lift the wire stop blade up.
7. Carefully remove the crimped terminal.
Maintenance
It is recommended that each operator of the tool be made aware of, and responsible for, the following
maintenance steps:
1. Remove dust, moisture, and other contaminants with a clean brush, or soft, lint free cloth.
2. Do not use any abrasive materials that could damage the tool.
3. Make certain all pins; pivot points and bearing surfaces are protected with a thin coat of high quality machine
4. Wipe excess oil from hand tool, particularly from crimping area. Oil transferred from the crimping area onto
5. When tool is not in use, keep the handles closed to prevent objects from becoming lodged in the crimping dies,
Miscrimps or Jams
Should this tool ever become stuck or jammed in a partially closed position,
closed. The tool will open easily by lifting the ratchet release lever. See Figure 3.
wire stop blade (See Figure 1). Align the wire so that it is parallel and sitting into the terminal. Maintain a
light and constant pressure on the wire that is seated in the terminal at all times. (Do not let go of the
wire.) Be sure to hold the wire and terminal in place until the terminal is fully crimped. See Figure 2.
Note: To maintain good brush control and a consistent bell mouth the crimping instructions must be
followed.
oil. Do not oil excessively. The tool was engineered for durability but like any other equipment it needs
cleaning and lubrication for a maximum service life of trouble free crimping. Light oil (such as 30 weight
automotive oil) used at the oil points, every 5,000 crimps or 3 months, will significantly enhance the tool life.
certain terminations may affect the electrical characteristics of an application.
and store the tool in a clean, dry area.
LOCATOR
TERMINAL
Figure 1
Release Date: 01-14-05
Revision Date: 04-24-08
PRE-STRIPPED
WIRE STOP
WIRE
BLADE
UNCONTROLLED COPY
LOCATOR
WIRE STOP
BLADE
Figure 2
TERMINAL
RETAINER
CONDUCTOR
Do Not force the handles open or
ANVIL
SPACER
INSULATION
CONDUCTOR
ANVIL
PUNCH
INSULATION
WIRE
PUNCH
Page 3 of 5