AC8 OPTO 22, AC8 Datasheet - Page 5

• Manufacturer Part Number: AC8
• Description: Computers, Interface Cards
• Manufacturer: OPTO 22

Specifications of AC8

• Peak Reflow Compatible (260 C): No
• Leaded Process Compatible: No
• Features: Half Duplex Modem Interface, 5VDC
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

DATA SHEET
Form 043-061030
Opto 22 • 43044 Business Park Drive • Temecula, CA 92590-3614 • Phone: [phone] • (800) 321-OPTO • Fax: [phone] • www.opto22.com
Delay
modems, no delay is required and neither jumper is installed.
Baud Rate
The AC8 must be set to the same baud rate as the modem and the Optomux network. The default baud rate is 1200 baud.
Data Flow Control
jumpers DTR, DSR, and DCD. This means that the corresponding signals are not available from your modem. If the jumpers are installed,
the above signals are always true.
can be used by a modem to determine if an AC8 is connected and operating.
The delay jumpers (Figure 3, set the delay from the Clear To Send (CTS) line to the beginning of data transmission (TXD). For most
The baud rate jumper (Figure 3) determines the baud rate of the AC8. Selectable baud rates are: 300, 600, 1200, 2400, 4800, and 9600.
This group of jumpers (Figure 4) configures the RS-232 interface (DTR, DSR, CTS, and DCD). The default jumper settings are to install
The DTR jumper should be installed if your modem expects this signal. If the jumper is installed, the signal is always true. This signal
Inside Sales: (800) 321-OPTO • Product Support: (800) TEK-OPTO • [phone] • Fax: [phone] • Email: [e-mail]
© 2004 Opto 22. All rights reserved. All trademarks, trade names, logos, and service marks referenced herein belong to their respective companies.
Delay 1
X
X
0
0
Jumpers 2
X
X
0
0
Figure 3 - Jumpers for selectable Delay and Baud Rate
1 milllisecond (default)
100 milliseconds
25 milliseconds
500 milliseconds
Delay Time
TRADITIONAL ADAPTER CARDS
INTERFACES
STAND-ALONE
page 5/11