72-7222 TENMA, 72-7222 Datasheet - Page 19
![MULTIMETER, DIGITAL, CLAMP, 3-1/2 DIGIT](/photos/27/66/276658/4423421_sml.jpg)
72-7222
Manufacturer Part Number
72-7222
Description
MULTIMETER, DIGITAL, CLAMP, 3-1/2 DIGIT
Manufacturer
TENMA
Datasheet
1.72-7222.pdf
(33 pages)
Specifications of 72-7222
Dmm Type
Clamp
Voltage Measuring Range Dc
200mV To 600V
Voltage Measuring Range Ac
2V To 600V
Current Measuring Range Ac
2A To 400A
Temperature Measuring Range
-40°C To +1000°C
Model 72-7222: OPERATING MANUAL
Measurement Operation(4)
The resistance ranges are:
200.0 , 2.000k , 20.00k ,200k ,2.000M
To measure resistance, connect the Meter as follows:
Note:
The test leads can add 0.1 to 0.3 of error to resistance
measurement.
l
l
l
l
l
l
1. Insert the red test lead into the
2. Set the rotary switch to
3. Connect the test leads across with the object being
For high-resistance measurement (>1M ), it normally
requires several seconds to obtain a stable reading.
If
for loose test leads, wrong function selected, or enabled
data hold function.
The LCD displays OL indicating open-circuit or the tested
resistor value is higher than the maximum range of the
Meter.
Resistance measurement is default to auto range mode.
Removing the object under test from its circuit will allow
more accurate measurement.
When resistance measurement has been completed,
disconnect the test leads from the circuit under test, and
remove them from the input terminals.
The measured value shows on the display.
the black test lead into the COM terminal.
( ) is default or press SELECT button to select
measurement mode.
measured.
reading with shorted test leads is not 0.5 , check
18
; resistance measurement
V
terminal and
and 20.00M .