B25832C4605K 9 TDK Corporation, B25832C4605K 9 Datasheet - Page 10
![no-image](/images/manufacturer_photos/0/6/653/tdk_corporation_sml.jpg)
B25832C4605K 9
Manufacturer Part Number
B25832C4605K 9
Description
Cap Film 6uF 640VAC 10% 45 X 57mm Solder Lug Metal Can
Manufacturer
TDK Corporation
Datasheet
1.B25832C4106K9.pdf
(10 pages)
Specifications of B25832C4605K 9
Package/case
45 X 57
Mounting
Solder Lug
Capacitance Value
6 uF
Voltage
640 Vac
Product Height
57 mm
Tolerance
10 %
Operating Temperature
-25 to 85 °C
The following applies to all products named in this publication:
1. Some parts of this publication contain statements about the suitability of our products for
2. We also point out that in individual cases, a malfunction of passive electronic components
3. The warnings, cautions and product-specific notes must be observed.
4. In order to satisfy certain technical requirements, some of the products described in this pub-
5. We constantly strive to improve our products. Consequently, the products described in this
6. Unless otherwise agreed in individual contracts, all orders are subject to the current version
7. The trade names EPCOS, CeraDiode, CSSP, PhaseCap, PhaseMod, SilverCap, SIFI, SIMID,
Important notes
certain areas of application. These statements are based on our knowledge of typical require-
ments that are often placed on our products in the areas of application concerned. We neverthe-
less expressly point out that such statements cannot be regarded as binding statements
about the suitability of our products for a particular customer application.
As a rule, EPCOS is either unfamiliar with individual customer applications or less familiar with
them than the customers themselves. For these reasons, it is always ultimately incumbent on the
customer to check and decide whether an EPCOS product with the properties described in the
product specification is suitable for use in a particular customer application.
or failure before the end of their usual service life cannot be completely ruled out in the
current state of the art, even if they are operated as specified. In customer applications re-
quiring a very high level of operational safety and especially in customer applications in which the
malfunction or failure of a passive electronic component could endanger human life or health
(e.g. in accident prevention or life-saving systems), it must therefore be ensured by means of suit-
able design of the customer application or other action taken by the customer (e.g. installation of
protective circuitry or redundancy) that no injury or damage is sustained by third parties in the
event of malfunction or failure of a passive electronic component.
lication may contain substances subject to restrictions in certain jurisdictions (e.g. be-
cause they are classed as “hazardous”). Useful information on this will be found in our Material
Data Sheets on the Internet (www.epcos.com/material). Should you have any more detailed
questions, please contact our sales offices.
publication may change from time to time. The same is true of the corresponding product
specifications. Please check therefore to what extent product descriptions and specifications
contained in this publication are still applicable before or when you place an order.
We also reserve the right to discontinue production and delivery of products. Consequent-
ly, we cannot guarantee that all products named in this publication will always be available.
of the “General Terms of Delivery for Products and Services in the Electrical Industry”
published by the German Electrical and Electronics Industry Association (ZVEI).
SIKOREL, SIOV, SIP5D, SIP5K, TOPcap, UltraCap, WindCap are trademarks registered or
pending in Europe and in other countries. Further information will be found on the Internet at
www.epcos.com/trademarks.
10
09/05