MT88E39AS1 Zarlink, MT88E39AS1 Datasheet - Page 6

• Manufacturer Part Number: MT88E39AS1
• Description: Caller ID CMOS 3.58MHz 3.3V/5V 16-Pin SOIC Tube
• Manufacturer: Zarlink

Specifications of MT88E39AS1

• Package: 16SOIC
• Telecommunication Standards Supported: ETSI 300 778-1|GR-30|SR-TSV-002476|TIA/EIA-716
• Fabrication Technology: CMOS
• Maximum Data Rate: 1212 Bd
• Typical Operating Supply Voltage: 3.3|5 V
• Typical Supply Current: 1.9 mA
• Minimum Operating Temperature: -40 °C
• Maximum Operating Temperature: 85 °C
• Operating Frequency: 3.58 MHz

Ringing, on the other hand, does not pose a problem as it is ignored by the carrier detector.
Crystal Oscillator
The MT88E39 uses either a 3.579545 MHz ceramic resonator or crystal oscillator as the master timing source.
The crystal specification is as follows:
Frequency:
Frequency tolerance:
Resonance mode:
Load capacitance:
Maximum series resistance:
Maximum drive level (mW):
e.g., CTS MP036S
For 5 V applications any number of MT88E39 devices can be connected as shown in Figure 5 such that only one
crystal is required. The connection between OSC2 and OSC1 can be DC coupled as shown, or the OSC1 input on
all devices can be driven from a CMOS buffer (dc coupled) with the OSC2 outputs left unconnected.
V
V
capacitor is required between CAP and V
Applications
Table 1 shows the Bellcore and ETSI FSK signal characteristics. The application circuit in Figure 6 will meet these
requirements.
For 5 V designs the input op-amp should be set to unity gain to meet the Bellcore requirements and -2.5 dB gain for
ETSI requirements.
As supply voltage (V
other than 5 V nominal voltage, to meet the FSK reject level requirement the gain of the op-amp should be reduced
accordingly.
For 3 V designs the gain settings for Bellcore and ETSI should be -3 dB and -5.5 dB respectively.
For applications requiring detection of lower FSK signal level, the input op-amp may be configured to provide
adequate gain. However, too much gain will cause noise tolerance to fail the TIA requirements because the FSK
signal will be clipped at GS when the single tone noise is added.
Ref
Ref
is the output of a low impedance voltage source equal to V
and CAP Inputs
DD
) is decreased, the FSK detect threshold will be lowered. Therefore for designs operating at
3.579545 MHz
±0.2%(-40°C+85°C)
Parallel
18 pF
150 ohms
2 mW
OSC1 OSC2
3.579545 MHz
MT88E39
Figure 5 - Common Crystal Connection
SS
to suppress noise on V
(For 5 V application only)
Zarlink Semiconductor Inc.
MT88E39
OSC1 OSC2
MT88E39
6
DD
/2
Ref.
and is used to bias the input op-amp. A 0.1 µF
OSC1 OSC2
next MT88E39
MT88E39
to the
Data Sheet