102155-3 Tyco Electronics, 102155-3 Datasheet - Page 93

• Manufacturer Part Number: 102155-3
• Description: Conn Ejector Header HDR 16 POS 2.54mm Solder ST Thru-Hole
• Manufacturer: Tyco Electronics
• Type: Ejector Headerr
• Series: AMP-Latch™r

Specifications of 102155-3

• Pitch: 2.54 mm
• Number Of Rows: 2
• Number Of Contacts: 16
• Gender: HDR
• Contact Plating: Gold Over Palladium Nickel|Gold Over Nickel
• Termination Method: Solder
• Contact Type: Male Pin
• Connector Type: Header, Shrouded
• Number Of Positions: 16
• Number Of Positions Loaded: All
• Row Spacing: 0.100" (2.54mm)
• Contact Mating Length: 0.240" (6.10mm)
• Mounting Type: Through Hole
• Termination: Solder
• Contact Finish: Gold or Gold-Palladium
• Contact Finish Thickness: Flash
• Color: Black
• Lead Free Status / RoHS Status: Lead free / RoHS non-compliant
• Features: -
• Fastening Type: -
• Lead Free Status / RoHS Status: Lead free / RoHS non-compliant
• Other names: 102155-3; AHJ16G

1. Place pinless header
2. With bottom of pc board
3. Apply an even, centered
over preinstalled posts
so that post tips start
into header cavities.
supported, place steel
block over header. Steel
block must be wider and
longer than header so
that it covers all four sides
of the header. However,
for headers with latches
pre-assembled, the steel
block must not interfere
with the latches.
force on steel block until
header bottoms on pc
board. If posts are
longer than .545 [13.84],
they may be forced
against the steel block
before the header is fully
seated. In this situation,
extreme caution must be
taken so that posts are
not damaged or pushed
out of the pc board.
93