AP513 TriQuint, AP513 Datasheet - Page 2

• Manufacturer Part Number: AP513
• Description: RF Amplifier 1805-1880MHz 30dB Gain
• Manufacturer: TriQuint
• Type: Power Amplifierr

Specifications of AP513

• Operating Frequency: 1805 MHz to 1880 MHz
• P1db: 39 dBm at 1840 MHz
• Operating Supply Voltage: 12 V
• Supply Current: 1.7 A
• Maximum Operating Temperature: + 85 C
• Mounting Style: Through Hole
• Minimum Operating Temperature: - 40 C
• Number Of Channels: 1 Channel
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

WJ Communications, Inc • Phone 1-800-WJ1-4401 • FAX: [phone] • e-mail: [e-mail] • Web site: www.wj.com, www.TriQuint.com
The AP513-PCB and AP513 module is configured for Class AB by default. The resistor – R7 – which sets the current draw for
the amplifier is set at 0 Ω in this configuration. Increasing that value will decrease the quiescent and operating current of the
amplifier module, as described on the next page.
RF IN
AP513
DCS-band 8W HBT Amplifier Module
DNP
0Ω
DNP
DNP
DNP
0Ω
Class AB Configuration (AP513-PCB)
DNP
6
100pF
.01μF
5
4
3
0Ω
2
DNP
DNP
1
10μF
DNP
100pF
.01μF
0Ω
DNP
RF OUT
Notes:
1.
2. The area around the module underneath the PCB should not contain any
3. For proper and safe operation in the laboratory, the power-on sequencing
Specifications and information are subject to change without notice
Please note that for reliable operation, the evaluation board and
mounting plate will have to be attached to a much larger heat sink
during operation and in laboratory environments to dissipate the
power consumed by the device.
recommended in laboratory environments. Details of the mounting holes
used in the WJ mounting plate are given on the last page of this datasheet.
soldermask in order to maintain good RF grounding.
should be followed:
1. Connect RF In and Out
2. Connect the voltages and ground pins as shown in the circuit.
3. Apply the RF signal
4. Power down with the reverse sequence
Product Information
The use of a convection fan is also
Page 2 of 5 June 2006