B45197-A2157-M509 EPCOS Inc, B45197-A2157-M509 Datasheet - Page 26

• Manufacturer Part Number: B45197-A2157-M509
• Manufacturer: EPCOS Inc

Specifications of B45197-A2157-M509

• Tolerance (+ Or -): 20%
• Voltage: 10VDC
• Esr: 100mOhm
• Mounting Style: Surface Mount
• Polarity: Polar
• Construction: SMT Chip
• Case Style: Molded
• Case Code: E
• Lead Spacing (nom): Not Requiredmm
• Df: 8%
• Dcl: 15uA
• Seal: Not Required
• Insulation: Not Required
• Failure Rate: Not Required
• Wire Form: Not Required
• Product Length (mm): 7.3mm
• Product Height (mm): 4.1mm
• Product Depth (mm): 4.3mm
• Product Diameter (mm): Not Requiredmm
• Seated Plane Height: Not Requiredmm
• Length W/weld (max): Not Requiredmm
• Operating Temp Range: -55C to 125C
• Capacitance: 150uF
• Package / Case: 7343-43
• Lead Free Status / RoHS Status: Compliant

The following applies to all products named in this publication:
1. Some parts of this publication contain statements about the suitability of our products for
2. We also point out that in individual cases, a malfunction of passive electronic compon-
3. The warnings, cautions and product-specific notes must be observed.
4. In order to satisfy certain technical requirements, some of the products described in this
5. We constantly strive to improve our products. Consequently, the products described in this
6. Unless otherwise agreed in individual contracts, all orders are subject to the current ver-
Important notes
certain areas of application. These statements are based on our knowledge of typical re-
quirements that are often placed on our products in the areas of application concerned. We
nevertheless expressly point out that such statements cannot be regarded as binding
statements about the suitability of our products for a particular customer application.
As a rule, KEMET is either unfamiliar with individual customer applications or less familiar
with them than the customers themselves. For these reasons, it is always ultimately incum-
bent on the customer to check and decide whether a KEMET product with the properties de-
scribed in the product specification is suitable for use in a particular customer application.
ents or failure before the end of their usual service life cannot be completely ruled out
in the current state of the art, even if they are operated as specified. In customer applica-
tions requiring a very high level of operational safety and especially in customer applications
in which the malfunction or failure of a passive electronic component could endanger human
life or health (e.g. in accident prevention or life-saving systems), it must therefore be ensured
by means of suitable design of the customer application or other action taken by the customer
(e.g. installation of protective circuitry or redundancy) that no injury or damage is sustained by
third parties in the event of malfunction or failure of a passive electronic component.
publication may contain substances subject to restrictions in certain jurisdictions (e.g.
because they are classed as “hazardous”). Should you have any more detailed questions,
please contact our sales offices.
publication may change from time to time. The same is true of the corresponding product
specifications. Please check therefore to what extent product descriptions and specifications
contained in this publication are still applicable before or when you place an or-
der.
We also reserve the right to discontinue production and delivery of products. Con-
sequently, we cannot guarantee that all products named in this publication will always be
available.
sion of the “General Terms of Delivery for Products and Services in the Electrical In-
dustry” published by the German Electrical and Electronics Industry Association
(ZVEI).
Page 26 of 26