1901139-1 TE Connectivity, 1901139-1 Datasheet

no-image

1901139-1

Manufacturer Part Number
1901139-1
Description
SPRING, TORSION
Manufacturer
TE Connectivity
Datasheet
1.1901139-1.pdf (4 pages)

Specifications of 1901139-1

Lead Free Status / RoHS Status
Supplier Unconfirmed
Hand Crimping Tool Frame Assembly 543344–1 is
designed to crimp the ferrule onto the shielding
hardware or cable clamps used with AMPLIMITE
HD–20 connectors. This tool accepts interchangeable
dies which corresponds to the ferrule being crimped.
E
Dimensions in this instruction sheet are in
millimeters [with inches in brackets]. Figures are
not drawn to scale.
Figure 1
Front of Tool
Reasons for reissue of this instruction sheet are
provided in Section 7, REVISION SUMMARY.
The tool consists of a flip–top head with a latch, die
holder plate, lower die holder, and handles with a
ratchet. The flip–top head allows easy removal of the
ferrule. The part number of the tool is on the front of
the tool.
This tool is a member of the CERTI–CRIMP* hand
crimping tool family. The ratchet on this tool ensures
full crimping of the product. Once engaged, the
ratchet will not release until the handles have been
FULLY closed.
1. Close the handles until the ratchet releases.
Allow the handles to open FULLY.
2. Place the moving die in the lower die holder.
Turn the die holding screw enough to hold die in
place. DO NOT tighten the screw.
3. Place the stationary die in the die holder plate.
Turn the die holding screw enough to hold the die
in place. DO NOT tighten the screw.
4. Make sure that the dies and properly aligned,
then close the handles, and tighten the die holding
screws.
1. Close the handles until the ratchet releases.
Allow the handles to open FULLY.
2. Loosen the die holding screws, and remove the
dies.
The dies bottom before the ratchet releases.
This feature ensures maximum electrical and
tensile performance of the crimp. DO NOT
re-adjust the ratchet.
Each set of dies consists of an anvil (moving die)
and a crimper (stationary die). Most moving dies
have square corners and the stationary dies have
chamfered corners. Refer to Figure 2. Exceptions
to this feature will be shown on the instruction
sheet packaged with the dies.

1901139-1 Summary of contents

Page 1

Figure 1 Hand Crimping Tool Frame Assembly 543344–1 is designed to crimp the ferrule onto the shielding hardware or cable clamps used with AMPLIMITE HD–20 connectors. This tool accepts interchangeable dies which corresponds to the ferrule being crimped. Dimensions in ...

Page 2

Die Holding Screw Crimper (Stationary Die) Anvil (Moving Die) 4. CRIMPING PROCEDURE 1. Close the handles until the ratchet releases. Allow the handles to open FULLY. 2. Open the latch, and looking into the front of the tool, insert the ...

Page 3

Close the tool handles until the ratchet releases and then allow them to open freely. If they do not open quickly and fully, the spring is defective and must be replaced. See Section 6, REPLACEMENT AND REPAIR. 2. Inspect ...

Page 4

ITEM PART NUMBER G 4 Hand Crimping Tool Frame Assembly 543344-1 REPLACEMENT PARTS DESCRIPTION G Figure 3 408-9315 QTY PER TOOL A ...