M68DEMO908GB60E Freescale, M68DEMO908GB60E Datasheet

no-image

M68DEMO908GB60E

Manufacturer Part Number
M68DEMO908GB60E
Description
Manufacturer
Freescale
Datasheet
1.M68DEMO908GB60E.pdf (2 pages)

Specifications of M68DEMO908GB60E

Architecture
8/16-bit
Code Gen Tools Included
Code Warrior
Lead Free Status / RoHS Status
Compliant
Freescale Semiconductor
Quick Start Guide
Getting Started with the
M68DEMO908GB60
The following steps provide a basic procedure to run the M68DEMO908GB60 demo board. Please refer
to the demo board user manual (M68DEMO908GB60man.pdf) in the Documentation folder of the demo
board CD for more detailed information.
Stop3 Demo
Paced Loop Demo
ATD/Timer Demo
© Freescale Semiconductor, Inc., 2005. All rights reserved.
1. Unpack demo board.
2. Ensure that the power switch (slide switch) is in OFF position.
3. Install batteries if necessary.
4. Set jumpers.
1. Slide power switch to ON position.
2. Observe LED1. LED1 will quickly flash twice a second. For more detail, refer to the Stop3 Demo
3. Press any pushbutton (SW1 through SW4) and observe the corresponding LED. If any switch is
4. Slide power switch to OFF position.
1. Hold SW2 low while switching power ON.
2. Observe LEDs 1 and 4 toggling at different rates. For more detail, refer to the Paced Loop Demo
3. Slide power switch to OFF position.
1. Hold SW3 low while switching power ON.
2. Observe LED5. For more detail, refer to the ATD/Timer Demo in the demo board user manual.
3. Momentarily hold SW1 low and observe the brightness of LED5 decrease. Subsequently,
4. Slide power switch to OFF position.
PWR_SEL jumper installed in positions 1–2. (Battery operation).
VRH_SEL jumpers — all off except jumper 5 (positions 9 and 10).
COM_EN jumpers — all installed.
LED_EN jumpers — all installed.
JP1 jumpers — positions 1–2 and 3–4.
in the demo board user manual.
held low for at least 0.5 second, the corresponding LED will stay lit for about 3 seconds after the
switch is released.
in the demo board user manual.
momentarily hold SW2 low and observe the brightness of LED5 increase.
Rev. 0.2, 01/2005

M68DEMO908GB60E Summary of contents

Page 1

... Observe LED5. For more detail, refer to the ATD/Timer Demo in the demo board user manual. 3. Momentarily hold SW1 low and observe the brightness of LED5 decrease. Subsequently, momentarily hold SW2 low and observe the brightness of LED5 increase. 4. Slide power switch to OFF position. © Freescale Semiconductor, Inc., 2005. All rights reserved. Rev. 0.2, 01/2005 ...

Page 2

... The serial monitor can be used for much more than just programming new code without a special debug pod. Many debug operations (memory modify, breakpoints, real-time bug traces, etc.) can also be run over the serial cable while in this mode. Refer to application note AN2140 for more information on the serial monitor. Getting Started with the M68DEMO908GB60, Rev. 0.2 2 Freescale Semiconductor ...